Can a front sway bar be added to a rear sway bar?
Although sway bars and kits are available for both the front and rear, the addition of only the rear sway bar (as noted by Bill Boorse) “will cause oversteer: the condition whereby the rear end breaks free and tends to travel toward the outside of the turn.”
Which is the best sway bar link kit?
Front & Rear Sway bar – Link Kit SKU: KLC31 The kit utilises a high tensile extruded alloy link fitted with ultra low compliance synthetic elastomer bushings. Critical hardware is replaced with high tensile components to match the higher loads. The result is much more precise and direct roll control with up to 25% more effective bar rate …
Why did I remove the rear sway bar on my MGB?
Some, who have done both conversions to their RB cars, have later removed the rear sway bar because of this characteristic. In some cases, this may be caused by the addition of the rear sway bar without adding a stiff enough front sway bar thereby unbalancing the car’s suspension.
Can a 77-80 sway bar be added to a RB?
Although the sway bar assembly from the later RB cars can, in theory, be added to the earlier cars with certain modifications and some welding, as noted by Llyod Faust “…in order to mount the rear bar, the factory moved the fuel pump out of the way (into the trunk). The 77-80 bar will also not clear the battery boxes in the two battery cars.
How to change the link on a sway bar?
Simple insert the lower part first, then the upper. Be sure it is installed the same as the original – the bushings are touching the sway bar – from the top: nut, metal washer, bushing, sway bar, bushing, metal washer. The lower link is simply nut, mounting point, smaller nut.
How to adjust control arm and sway bar?
Torque the control arm end of the link through bolt/nut to 34-39 ft-lbs (46.1~52.9 nm). Leave the sway bar end of second end link disconnected. Leave both jam nuts loose. 9. Adjust second link length as needed to allow through bolts to align with both control arm and sway bar ends without having to force into place.
How do you adjust sway bars on a trailer?
The sway bars should come with adjustment screws that need a little turn, either way, to make sure you have the right tension on your trailer. To make sure you know which way to turn those screws, you should do a test drive with your tow vehicle and your trailer filled with the same weight you will have on your trip.
How to adjust sway bar on 4 post hoist?
Position the car at resting ride height but on ramps or a 4 post hoist where you can access the end links for adjustment. Adjust link length so sway bar is as close to our 90° ideal as you can get it without interfering with the FUCA.