Can you remove pushrods from GM V6 engine?
As, stripped rocker bolts, is common, while doing this repair. The pushrod removal to is for, the newer 3.5L and 3.6L GM engines. But, also works on GM V6 2.8L, 3.1L and 3.4L. It helps you quickly remove pushrods, so you can replace the intake gasket.
How big is the pushrod on a G m 4 engine?
The tool pivots the rocker arm to compress the valve spring and free, the pushrod for removal. Exhaust and Intake Pushrods on G.M. 3.1 and 3.4 engines are different lengths. The intake valve pushrod measure 144 mm (5.75 in) long.
How to adjust GM 3400 3.4L pushrod rocker arms?
Intake valves are closer to the valley of the engine. No compression on 3.4 V6 Aztec, replaced one cylinder head only but did remove push rods etc from both to replace gaskets, also turned the engine over without push rods good compression, left overnight still no compression any one have any ideas I am stumped. Lifters?
What do you need to know about intake push rods?
The most important thing is that the push rods are installed correctly. They are different lengths. GM recommends new lower intake bolts, and have updated the torque specs on the rocker arms and lower intake bolts. More Questions For… The intake and exhaust rocker / Pushrods are labeled in the picture below.
As, stripped rocker bolts, is common, while doing this repair. The pushrod removal to is for, the newer 3.5L and 3.6L GM engines. But, also works on GM V6 2.8L, 3.1L and 3.4L. It helps you quickly remove pushrods, so you can replace the intake gasket.
The tool pivots the rocker arm to compress the valve spring and free, the pushrod for removal. Exhaust and Intake Pushrods on G.M. 3.1 and 3.4 engines are different lengths. The intake valve pushrod measure 144 mm (5.75 in) long.
Intake valves are closer to the valley of the engine. No compression on 3.4 V6 Aztec, replaced one cylinder head only but did remove push rods etc from both to replace gaskets, also turned the engine over without push rods good compression, left overnight still no compression any one have any ideas I am stumped. Lifters?
The most important thing is that the push rods are installed correctly. They are different lengths. GM recommends new lower intake bolts, and have updated the torque specs on the rocker arms and lower intake bolts. More Questions For… The intake and exhaust rocker / Pushrods are labeled in the picture below.