Why does the security light stay on when you turn on the ignition?
If when you turn the ignition ON, the “Security” light stays on or is flashing; it means that your car security system does not recognize the key or; there is some problem with some part of the security system itself. So, there is a test for pretty much any part of your vehicle.
Why is the anti security light not blinking?
Anti security light is on not blinking and car won’t star… replace starter and had battery tested good and now car won’t start’ red anti security light is on but not flashing My car has 173330 miles. My car has an automatic transmission. The anti-theft system is engaged. You will need to have the system scanned to see why the system is active.
Why does my GM car say no start no crank?
How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.
What to do if your check engine light won’t turn on?
They might also tell you its an o2 sensor, ask them to show you on the car where it is. then buy a 02 sensor and replace it your self. saving you about a $100. remember any light that comes on in your car go have it check out and do the work yourself. saving you lots of cash. Was this answer helpful? Was this answer helpful?
Is it normal for the security light to go off when the engine is running?
After the learn procedure is completed and the engine is running, the security light may stay on steady for a few minutes and then go off—this is normal. Depending on the system, replacement of key components will necessitate that a relearn procedure be completed.
Why does my car not start when I Turn on the ignition?
When you insert it into the ignition, a sensor for the security system reads the code. Normally when you turn the ignition on; you would see a “Security” light come on for a short time and then go out. As a result, that would mean that the code in the ignition key is correct; and the car is allowed to start.
Why does my PassLock security light keep going off?
After turning the ignition off for the third time and waiting for twenty seconds, the engine should start and run. If it doesn’t, there may still be something wrong with the system. After the learn procedure is completed and the engine is running, the security light may stay on steady for a few minutes and then go off—this is normal.
Why is my car engine not cranking over?
If your engine is not cranking over; you are probably dealing with a starter or battery problem.