How much does it cost to Replace fuel injectors?
On average, you can expect to pay between $350 and $850 to replace your fuel injectors. The range of costs depends on a number of factors. Smaller vehicles with fewer cylinders requiring less expensive parts will come in at the lower end of the spectrum.
What does a fuel injector do in a Grand Prix?
A fuel injector’s programmable firmware allows it to handle different fuels. A fuel injector consists of only the nozzle and valve; it still requires the pump to pressurize the fuel. Determine which fuel injector your Pontiac Grand Prix will need. This depends not only on the make and model, but also the engine size.
Do you need a fuel injector in a Jeep Grand Cherokee?
A fuel injector is only a nozzle and a valve; it still requires a pump to inject the fuel into the engine. Determine which fuel injector your Jeep Grand Cherokee will need. This depends not only on the make and model, but also the engine size.
When did a fuel injector replace a carburetor?
This technology almost completely replaced carburetors in the late 1980s and its programmable firmware allows the same hardware to be used with different fuels. A fuel injector is only a nozzle and a valve; it still requires a pump to inject the fuel into the engine. Determine which fuel injector your Jeep Grand Cherokee will need.
What should fuel injector resistance be in GM 3.8L?
The fuel injector resistance should be around 11.4 to 12.6 Ohms (although on your specific GM 3.8L car, this value might be a little different). Repeat test steps 1 through 4 on the remaining 5 fuel injectors.
What kind of fuel injector does a Pontiac Grand Prix use?
The Pontiac Grand Prix mixes fuel and air under pressure with a fuel injector. Carburetors previously performed this function passively but were rendered obsolete by fuel injectors in the late 1980s. A fuel injector’s programmable firmware allows it to handle different fuels.
How do you replace fuel injectors on a car?
Disconnect the electrical connectors from the fuel injectors. Remove the fuel rail mounting bolts with a socket wrench and release the retaining clips on the fuel injectors. Pull the fuel injectors from the fuel rail. Discard the old O-rings. Install the new fuel injectors by reversing the removal procedure.
The fuel injector resistance should be around 11.4 to 12.6 Ohms (although on your specific GM 3.8L car, this value might be a little different). Repeat test steps 1 through 4 on the remaining 5 fuel injectors.
Can you replace the fuel injector in an AC Delco?
Replace the fuel injector. If you’d like to buy the original AC Delco (or aftermarket) fuel injector and save a few bucks, take a look at the section: Where To Buy The Fuel Injector And Save.