How do you remove the radio from the dash of a Pontiac?
The bolts are located right along the side of the dash and will run up the edge. Use a screwdriver to unfasten the radio bracket to remove the radio. Unhook all electrical wiring from the back side of the radio. Slide the radio straight out of the dash of the car.
Where is the Speedo cable on a Pontiac?
Working through the glove box hole locate and remove three 1/2-inch nuts securing studs along the top underside of the pad. These are easily found by looking under the dash. Now reach up through the U-shaped area where the steering column was and disconnect the speedo cable.
Where is the radio bracket on a Pontiac?
Open both driver-side and passenger-side doors and locate bolts that are securing the dash directly to the frame. The bolts are located right along the side of the dash and will run up the edge. Use a screwdriver to unfasten the radio bracket to remove the radio.
How do you put a dash pad on a Pontiac?
It is held in place with a pressure clip. Push the clip in at the bottom and pull the cable out from the back of the gauge cluster. Remove two 9/16-inch bolts from each lower corner of the pad which secure it to the car and two more on either side of the steering column hole. You can now pull the pad forward enough to see behind it.
The bolts are located right along the side of the dash and will run up the edge. Use a screwdriver to unfasten the radio bracket to remove the radio. Unhook all electrical wiring from the back side of the radio. Slide the radio straight out of the dash of the car.
Working through the glove box hole locate and remove three 1/2-inch nuts securing studs along the top underside of the pad. These are easily found by looking under the dash. Now reach up through the U-shaped area where the steering column was and disconnect the speedo cable.
Open both driver-side and passenger-side doors and locate bolts that are securing the dash directly to the frame. The bolts are located right along the side of the dash and will run up the edge. Use a screwdriver to unfasten the radio bracket to remove the radio.
It is held in place with a pressure clip. Push the clip in at the bottom and pull the cable out from the back of the gauge cluster. Remove two 9/16-inch bolts from each lower corner of the pad which secure it to the car and two more on either side of the steering column hole. You can now pull the pad forward enough to see behind it.