What is the function of a trans axle?
The trans-axle is compact and combines all the functions of the separate assemblies, it’s main function is to transfer engine power into forward motion. Depending on how sophisticated it is, you may have reverse motion and variable speed control.
What makes up the axle on a lawn mower?
Contained within the axle is the drive shafts and differential. The differential job is to allow one wheel to move independent of the other, this is useful when turning corners as the outer wheels of a mower travels further than the inner wheels.
What are the axles on a compound bow?
The axles on a compound bow work just like the axles on your car. They are the shaft on which the cams rotate. The distance between the two is often referred to as axle to axle (ATA) length. The average modern compound bow has an ATA of about 30 inches, although some are as short as 18 inches.
How are the wheels attached to the front axle?
The figure shows front axle components with the steering linkage. The wheels are fixed on the stub axles which are usually pivoted. From the stub axle, the inclined steering arms are connected to the track rod ends, and a third steering arm is attached to the drag link.
Is the front axle a live axle or a dead axle?
Live front axle. Dead front axle. The front axles are usually dead axles because they do not rotate, in contrast to the live axles that they are used in the rear axle to transmit power to the rear wheels.
What kind of material is a front axle made of?
It is made of I-section in the centre portion, while the ends are made either circular or elliptical. With this construction, it takes bending loads due to the load of the vehicle. Also, the torque centre portion is given a downward sweep. The different components of the front axle are the beam, stub axle, swivel pin and track rod.
Why are front axles called full floating axles?
Thus the axle is relieved of all strain caused by the weight of the vehicle on the end thrust. It transmits only the driving torque. For this reason, it is called full floating. The axle may be removed from the housing without distributing the wheel by removing the nuts.