What order should I bleed my brakes?
- The order on most cars is starting with the passenger rear brake first, then driver rear, then passenger front and finishing with the driver front.
- Check the brake fluid level after you’re done bleeding each brake, and make sure it stays above the indicator line.
- Add more fluid as needed.
Where do you Bleed the brake lines on a Pontiac Grand Prix?
It is recommended that you begin bleeding the brakes lines at the wheel farthest from the master brake cylinder and then working your way towards the brake cylinder. On the 1997-2003 Grand Prix, that would be rear passenger wheel first, then the driver side rear wheel, passenger side front wheel and finally the driver side front wheel.
What should I do if my GM brakes are bleeding?
The modulator motor pack, isolation solenoid valves, gear cover and individual gears are all serviceable parts and can be replaced separately. The brakes on GM cars equipped with Delco ABS-VI may be bled using manual, vacuum or pressure bleeding. The usual bleeding sequence is right rear, left rear, right front, left front.
What kind of brake fluid does a Grand Prix use?
You can use either DOT 3 or DOT 4 fluid which are both glycol based. Do not use DOT 5 brake fluid, which is silicon based and is not compatible with the 97-03 Grand Prix braking system. Next I removed the plastic lug nut caps with a 19mm socket and loosened the lug nuts with the lug wrench.
When did I replace my front brake pads?
My 2001 Pontiac Grand Prix GTP is about to hit the 91,000 miles mark on the odometer. The rear brake pads are the originals and the front brake pads were replaced during the 60,000 mile service.
It is recommended that you begin bleeding the brakes lines at the wheel farthest from the master brake cylinder and then working your way towards the brake cylinder. On the 1997-2003 Grand Prix, that would be rear passenger wheel first, then the driver side rear wheel, passenger side front wheel and finally the driver side front wheel.
My 2001 Pontiac Grand Prix GTP is about to hit the 91,000 miles mark on the odometer. The rear brake pads are the originals and the front brake pads were replaced during the 60,000 mile service.
You can use either DOT 3 or DOT 4 fluid which are both glycol based. Do not use DOT 5 brake fluid, which is silicon based and is not compatible with the 97-03 Grand Prix braking system. Next I removed the plastic lug nut caps with a 19mm socket and loosened the lug nuts with the lug wrench.
What do you need to bleed a brake line?
Once I verified that the bleeder valves at each rear brake caliper could be easily opened, I called out my assistant to the garage. To successfully and safely bleed the brake lines, you’ll need a large bottle of new DOT 3 or 4 brake fluid, a 10mm wrench, some plastic tubing and a catch container for the old brake fluid such as a plastic bottle.