What is the camshaft position sensor on a Pontiac?
On some Pontiac models the camshaft position sensor is part Ignition Control Module (ICM) (aka igniter). If playback doesn’t begin shortly, try restarting your device.
What happens when the camshaft position sensor fails?
Once your car’s computer detects a CMP sensor failure, it will trigger the engine light and store a diagnostic trouble code (DTC) in its memory (see the table below for common camshaft position sensor trouble diagnostic codes). As you may expect, the specific location of the camshaft position sensor varies by a vehicle’s make and model.
How to diagnose p0016 on a Pontiac G6?
This is a great place to start diagnosing P0016 in your Pontiac G6. It’s quick and easy to do this before moving on to the sensors themselves. Make sure to check the harness where it plugs into both sensors as well. After examining the wiring harness, it would be time to check the sensors themselves.
How much does a bad camshaft sensor cost?
In this case, because of an inaccurate reading from a bad camshaft position sensor, more fuel than necessary is injected into the engine which causes your fuel economy to drop. To replace a camshaft position sensor, you can expect to pay anywhere from $120 to $300. Parts alone will run about $50 to $200.
On some Pontiac models the camshaft position sensor is part Ignition Control Module (ICM) (aka igniter). If playback doesn’t begin shortly, try restarting your device.
How to replace a bad camshaft position sensor in your car?
How to replace a bad camshaft position sensor in your car, DIY with Scotty Kilmer. They often go bad and turn your check engine light on and Code P0340. DIY car repair with Scotty Kilmer, an auto mechanic for the last 49 years. 1. Actron Scan Tool: http://amzn.to/2jxoUXq 2. Telescopic Magnet Pick Up: http://amzn.to/2jyDRZm 3. Common Sense 5.
How much does it cost to diagnose the p0341 Pontiac code?
The cost of diagnosing the P0341 PONTIAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0341 PONTIAC code detected?
What is the crank sensor on a GM 3.1L engine?
This article will help you test the ignition control module (ICM) and 3X crankshaft position sensor on all of the GM 3.1L and 3.4L overhead valve engines (the 3X crank sensor is also known as the 7X Crank Sensor).
Where is the crank sensor located on an engine?
One is located behind the crankshaft pulley on the front of the engine and the other is the same one described above. In a two crankshaft position sensor engine, the one that’s located behind the crank pulley is known as the 24X crank sensor and the other is called the same (3X or 7X crank sensor).
When does the crankshaft position sensor become inoperative?
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals. Need more information on how to fix the P0341 PONTIAC code?