What does the coolant temperature sensor do on a car?
The coolant temperature sensor, also known as the coolant temperature switch, is the engine management system that monitors the temperature of the coolant and relays this information to the ECM. When the sensor is functioning properly, it will tell your on board computer if the temperature is too high,…
How much does it cost to replace a coolant temperature sensor?
Unscrew the ECT sensor in an anticlockwise direction, similar to how a spark plug is removed. Install the new sensor and reconnect the connector cable. The average replacement cost of the Coolant Temperature Sensor is between $100 and $220. The labour cost is between $40 and $140 while the part itself costs between $50 and $80.
Can a bad coolant sensor cause a car to not start?
Some cars use the engine coolant temperature sensor to control the electric cooling fans. You have two separate temperature sensors for the fans, dashboard gauge, and engine management in most cars. However, if your car has a single sensor, a bad engine coolant temperature sensor may result in your fans won’t start at all.
What should coolant temp be when engine is hot?
With a good OBD2 code reader, you can also check the live data and the parameters of the CTS sensor. Check that the temperature value of the CTS is around 80-90c when the engine is hot. A lot of engine coolant temperature sensors have two wires and the sensor is controlled by Ohm.
What kind of engine problem does a 2005 pintiac G6 have?
Please try again later. Diagnosis of a Drivability issue and Fuel Consumption concern Due to a Faulty Engine Coolant Temperature (ECT) Sensor on a 2005 Pintiac G6 (code P0118 logged). For more information on RepairSolutions® and available promotions, please visit www.innova.com/youtube.
What to do when your coolant sensor is replaced?
Properly dispose of used coolant. Step 16: Lower vehicle from jack stands. Place the vehicle back level to the ground. Once the coolant temperature sensor has been replaced, you need to start the engine, check for leaks, and refill the radiator fluid in most cases before you test drive the vehicle.
How can I check the coolant level in my car?
Step 1: Start the vehicle. Let it warm up to operating temperature. Step 2: Check for leaks. Be sure to check for leaks from the radiator drain plug, petcock, or the coolant temperature sensor. Step 3: Check to see if the check engine or low coolant level light is illuminated.
The coolant temperature sensor, also known as the coolant temperature switch, is the engine management system that monitors the temperature of the coolant and relays this information to the ECM. When the sensor is functioning properly, it will tell your on board computer if the temperature is too high,…
Where is coolant temp sensor on GM 3800?
Coolant Temp sensor (ECT) 9. Evap Purge Solenoid Typical engine data sensor and control component locations on the GM 3.8L 3800 v6 engine. Exact location may vary depending on vehicle year / make / model. Click on a number for a description of the component. A few related auto repair questions and answers.
Properly dispose of used coolant. Step 16: Lower vehicle from jack stands. Place the vehicle back level to the ground. Once the coolant temperature sensor has been replaced, you need to start the engine, check for leaks, and refill the radiator fluid in most cases before you test drive the vehicle.
Please try again later. Diagnosis of a Drivability issue and Fuel Consumption concern Due to a Faulty Engine Coolant Temperature (ECT) Sensor on a 2005 Pintiac G6 (code P0118 logged). For more information on RepairSolutions® and available promotions, please visit www.innova.com/youtube.