How to relearn Ford Pats code erase procedure?
Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. 2 keys required. Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.
When do I need to relearn the security key?
Start the If the vehicle starts and runs normally, the relearn is complete. If additional keys need to be relearned: Insert the next key to be Turn the key to the “ON” position within 10 seconds of removing the previously used key. Wait for security light to turn It should happen fairly quickly.
How to relearn Pats ignition key code program?
Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”
How to run Ford Pats relearn procedure module?
Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.” Disconnect Tool and leave key in RUN for 20 seconds. 1 key required. Cycle key 1 to RUN, then OFF. Cycle new key to RUN. 2 keys required. Cycle key 1 to RUN, then OFF. Cycle key 2 to RUN, then OFF. Cycle new key to RUN. Cycle a key in ignition to RUN.
What are the relearn procedures for PassLock system?
The Passlock system has two basic relearn procedures—a ten-minute procedure and a thirty-minute procedure. Which one you use depends on the system and what components have been replaced. The ten-minute procedure involves trying to start the engine.
Start the If the vehicle starts and runs normally, the relearn is complete. If additional keys need to be relearned: Insert the next key to be Turn the key to the “ON” position within 10 seconds of removing the previously used key. Wait for security light to turn It should happen fairly quickly.
How does coding for services attempted but not completed?
Some carriers are using the previous method and giving physicians credit as described. Some carriers seem to be requiring “further development” (whatever that means) in order to count in the ROS. The payors, however, do seem to read JUCM.
How to relearn the passkey II security module?
To perform a relearn on a Passkey II system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming.