What to do if turbine shaft speed sensor is not working?
The TCM also monitors the turbine speed sensor itself for problems, which it would expect to find in a certain range and change speeds at a certain rate. If the TCM detects problems with the TSS or TSS circuit, it will set a diagnostic trouble code (DTC) in memory and command the ECM to illuminate the check engine light.
What does p0717 input turbine speed sensor circuit no signal trouble code?
If you have a P0717 Input Turbine Speed Sensor Circuit No Signal trouble code, this post will help you understand what it is and how to fix it. The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft.
What is the diagnostic code for input speed sensor?
P0715 is a diagnostic trouble code (DTC) for “Input/Turbine Speed Sensor Circuit Malfunction”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What is the fault code for turbine shaft?
Thanks, Input and output shaft sensors or signal failure problems should throw fault codes P0717 & P0722. I have the workshop manual for this car with all the wiring diagrams, and ohms values to check etc, so i’ll give your recommendations a try….
The TCM also monitors the turbine speed sensor itself for problems, which it would expect to find in a certain range and change speeds at a certain rate. If the TCM detects problems with the TSS or TSS circuit, it will set a diagnostic trouble code (DTC) in memory and command the ECM to illuminate the check engine light.
If you have a P0717 Input Turbine Speed Sensor Circuit No Signal trouble code, this post will help you understand what it is and how to fix it. The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft.
Where is the sensor located on a turbine?
Its directly on top of the transmission, should have two wires to it, and if you can bend your arm, all you need to remove is the stock airbox to get to it. Connect the new sensor,do everything above in the reverse order. Hey so did everything go back to normal? any problems after the change?
Thanks, Input and output shaft sensors or signal failure problems should throw fault codes P0717 & P0722. I have the workshop manual for this car with all the wiring diagrams, and ohms values to check etc, so i’ll give your recommendations a try….