Why does my car make a squeaking noise?
The most common fault with the pulley is worn bearings inside of it. Once the pulley gets worn out it may start rubbing itself against the engine’s belt. This will produce the squeaking noise which gets even worse as you continue driving the car. If not replaced immediately it may cause damage to parts around the belt if it fails.
Why does the idler pulley make a squealing noise?
When the serpentine belt breaks, you have bigger problems to deal with. The engine might stall or overheat as a result. Plus, the squealing noise is going to become consistently louder, creating an annoying ride. The idler pulley and belt are located near the front of the engine.
Why does my pulley make a noise when I start the car?
The pulley itself has an outer ring and an inner bearing. If the pulley is making noise, either it’s the result of a bearing failure or the spring is not providing the proper tension. Start your vehicle, leave the transmission in park, set the parking brake and open the hood.
How can I tell if my engine pulley is faulty?
Another way to spot a faulty pulley is to switch on the engine and then observe how the belt moves. A functioning pulley should rotate the belt in an even way. However, if you notice that your belt is wobbling – especially when you rev up the engine – then your pulley is faulty.
The pulley itself has an outer ring and an inner bearing. If the pulley is making noise, either it’s the result of a bearing failure or the spring is not providing the proper tension. Start your vehicle, leave the transmission in park, set the parking brake and open the hood.
How to troubleshoot a tensioner pulley noise?
Rotate the tensioner counterclockwise just far enough to slip the serpentine belt off the pulley closest to the belt (or pulley easiest for you to reach, depending on what kind of vehicle you’re working on). Rotate the tensioner back into position. Shine the flashlight on the tensioner pulley and examine the pulley face.
How can you tell if a tensioner pulley is glazing?
Shine the flashlight on the tensioner pulley and examine the pulley face. If there’s evidence of glazing on the pulley surface, the belt has been slipping on it.
What to do when you hear a tensioner noise in your car?
Start your vehicle, leave the transmission in park, set the parking brake and open the hood. Listen to the tensioner noise to note if the sound is intermittent or constant.