Is there a way to bypass PassLock 2?
The easiest way to bypass the Passlock 2 system is to place a resistor between the passlock sensing wire and the ground reference wire. To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel. Usually, they are orange/black, red/white, and black.
Why do I need to turn off PassLock on my truck?
The passlock feature on my truck engages occasionally without cause, making me sit and wait out the 10-minute delay. This is always inconvenient and has the potential for being a safety hazard. Does anyone have an idea for how I can permanently disable this feature? Answered! View the answer I have this problem too Is this a good question?
How much of a value can a PassLock system accept?
You can be within about 5% of the value, and it will be accepted by the passlock system as genuine. Once you have assembled the resistors so they represent the correct value, tightly wrap one end of the resistor through and around the exposed copper of the black wire.
Where is the resistor on a PassLock module?
Now you take the cut wire that leads toward the Passlock module (NOT toward the ignition barrel) and connect the other end of the resistor to this wire, being sure to tape it to protect against shorting. Once that is done, be sure to tape the exposed cut wire that leads to the ignition barrel.
The easiest way to bypass the Passlock 2 system is to place a resistor between the passlock sensing wire and the ground reference wire. To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel. Usually, they are orange/black, red/white, and black.
Is there a problem with the PassLock sensor?
The short answer is there’s a problem with the sensor. Some have suggested that the pins in the system are “tin” plated and subject to oxidization over time. Others say their system is possessed by the devil and in need of an exorcist.
You can be within about 5% of the value, and it will be accepted by the passlock system as genuine. Once you have assembled the resistors so they represent the correct value, tightly wrap one end of the resistor through and around the exposed copper of the black wire.
What is the system fault code for PassLock security?
When the sensor defect starts, it usually presents itself as system fault code B2960. A red (or yellow) “security” warning light will stay illuminated and the engine will either a) never start or b) start for a moment and then shut down.