Are there rear disc brakes on a Pontiac Firebird?
When you checked that option on the order form, you received four-wheel power disc brakes. Having rear disc brakes in 1979 was considered exotic and, in the GM family, they were usually only available on the Corvette. Rear disc brakes greatly simplified repairs and improved braking performance.
How do you change the brake system on a Firebird?
The braking system of the second-generation Firebird is very good and is relatively inexpensive to replace. Use a lug wrench or breaker bar and socket to remove the lug nuts from the front wheel that is receiving brake service. I advise breaking the torque on the lug nuts before jacking up the car. Use a breaker bar and socket.
Where is the retainer ring on a Pontiac Firebird?
Use a 3/8-inch line wrench to remove the short section of rubber brake line from the steel brake line at the bracket. A retainer ring is located at the back side of the brake line bracket. Use a flat-head screwdriver or pick to snag it and lift it out. A dust cap is at the center of the brake rotor.
How do you remove the rotor on a Pontiac Firebird?
Slide the rotor out slightly to remove the keyed washer and outer bearing. You need to remove the bearing and grease seal from the rotor. To do this, reinstall the spindle nut and turn it clockwise a few threads. Grab the rotor with your hands placed at the three and nine o’clock positions.
When you checked that option on the order form, you received four-wheel power disc brakes. Having rear disc brakes in 1979 was considered exotic and, in the GM family, they were usually only available on the Corvette. Rear disc brakes greatly simplified repairs and improved braking performance.
What kind of brakes did Pontiac Trans Am have in 1979?
The 1979 model year brought a major change to the Special Performance Package (RPO WS6). When you checked that option on the order form, you received four-wheel power disc brakes. Having rear disc brakes in 1979 was considered exotic and, in the GM family, they were usually only available on the Corvette.
Where is the brake hose on a 1979 Pontiac Firebird?
Install the brake hose by placing one end at the caliper and installing a new copper washer, which should have been included with the new hose. Reuse the bolt you removed earlier. The 1979 model year brought a major change to the Special Performance Package (RPO WS6).
Where are the caliper pins on a Pontiac Firebird?
To do that, locate the caliper pins on the back side of the caliper. To gain easier access to the caliper pins, turn the steering so the rear is pointing outward. Use a 3/8-inch Allen socket on a 3/8- or 1/2-inch ratchet to loosen the upper and lower caliper pins.