What should the cut speed be on a scanncut?
Start with a blade-depth setting of 6 on the cartridge and the default settings for cut speed of 3 and cut pressure of 0 using the Tools function. Use the test mode to cut a square of about 1″.
Why does my Silverado scan tool not turn on?
So, verify that you have a blown 15A fuse, and if so, bang in a 15A fuse and you should be good to go. Keep in mind that this doesn’t tell you why the fuse blew, although 9/10 times using a cell phone charger in one of the 12v acc ports is the cause. Loading…
What to do if the OBD II scanner doesn’t communicate with the vehicle?
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.
Do you need to clean the bottom of a scanner?
Your scanner may need to be cleaned. To do this, open the compartment on the bottom of the scanner to expose the scanner glass. Wipe clean with a dry, lint free cloth and secure the cover.
When does a permanent DTC get erased by scan tool?
A Permanent DTC will be erased one of two ways: After three consecutive confirmed fault-free monitoring cycles. The MIL is extinguished and the Permanent DTC is cleared at the start of the fourth fault-free monitoring cycle. After one confirmed fault-free monitoring cycle following a scan tool “clear DTC” request.
How to fix a car that won’t communicate with a scan tool?
This feature is not available right now. Please try again later. Scotty Kilmer, mechanic for the last 48 years, shows how to fix a broken car the won’t communicate with a scan tool so you can’t get any information on the problem. Sometimes it’s as easy as just disconnecting parts to find the problem. 1. Actron Scan Tool: http://amzn.to/2ngeCQJ 2.
When to clear a permanent diagnostic trouble code ( DTC )?
A Permanent Diagnostic Trouble Code (DTC) is stored when a DTC is confirmed and the Malfunction Indicator Lamp (MIL) has been illuminated. A Permanent DTC can only then be cleared by the module strategy and cannot be erased by clearing DTCs with a scan tool, a Keep-Alive Memory (KAM) reset, or battery disconnect.
When to remove a DTC from a vehicle?
The intended use of the Permanent DTC is to prevent vehicles from passing an in-use inspection simply by disconnecting the battery or clearing DTCs with a scan tool prior to the inspection. A Permanent DTC will be erased one of two ways: After three consecutive confirmed fault-free monitoring cycles.