When to replace radiator cap on Camaro Firebird?
At about the four minute mark the thermostat should open, which will drop the level of the coolant. Refill as necessary until the level stays up to the top. It will probably take about three rounds of refill to get it to stay there. Once it’s full, replace the radiator cap and ensure the overflow bottle is up to the hot line.
How do you change the radiator on a Camaro?
Loosen the hose connection at the radiator and slowly remove the hose, allowing the coolant to flow into your drain pan. You may also want to open the drain plug anyway, as there will still be some coolant in the bottom of the radiator. If not, just be prepared for some residual coolant since it won’t drain completely.
When to change the coolant in your Radiator?
After 4 to 6 years or after driving 40,000 to 60,000 mi (64,000 to 97,000 km), it’s recommended that you change the coolant in your radiator to keep your engine running well. Changing the coolant requires draining the existing fluids and flushing the system before you add a new antifreeze solution.
Can a broken radiator fan be replaced in a Ford Ranger?
1A Auto shows you how to repair, install, fix, change or replace a broken radiator fan. If your car overheats or runs hot and the radiator cooling fan will not turn on then this may be your solution. This video shows the process for the 90, 91, 92, 93, 94, 95, 96, 97, 98, 99, 00, 01, 02, 03, 04 Ford Ranger
How do you flush the radiator in a Camaro?
Coolant overflow tank bolt location and hose removal. Fill your radiator with distilled water, which should take about two gallons. Leave the radiator cap off for now. Once you get the radiator filled with distilled water, get into the driver’s seat, turn your heater knob all the way over to hot, then start your car.
How long does it take to flush radiator coolant?
Open this and let the coolant drain out. This can take around 10 minutes or so. Expect about eight (8) quarts of fluid to drain, so ensure your drain pan is large enough to accept the liquid. Once the coolant drain slows to a trickle, close the petcock. Figure 1. LS1 drain petcock.
How do you get coolant out of the radiator?
As long as the engine is cool, remove the radiator cap and set it aside. Place your drain pan under the radiator on the passenger side. On the bottom of the radiator you’ll find the drain petcock (Figure 1). Open this and let the coolant drain out. This can take around 10 minutes or so.
What kind of coolant does a Camaro Z28 have?
This article applies to the Camaro Z28/SS (1998-2002) and Pontiac Formula/Trans Am (1998-2002). Your vehicle originally came with the orange sauce known as Dex-Cool. Maybe it’s been changed to the green stuff? Your car won’t mind either color. What it does mind is when the coolant becomes worn out.