How much transmission fluid does a 97 4L60E?
The fluid capacity of the 4L60e is 12 quarts of transmission fluid (dry). This amount is based on a stock, “shallow” transmission pan with a 12″ torque converter. With a deep pan, the capacity of additional fluid can vary from an extra quart or more.
How do you change the transmission fluid on a 4L60E?
Removal Procedure
- Locate the upper transmission line on the passenger side and remove the line from your vehicle’s radiator.
- Once the line is removed, connect your brass trans cooler line fitting.
- Route the tubing to your catch pan or bucket.
- Now you will begin to flush the fluid.
When did the GM 4L60 E transmission come out?
The 4L60-E is the “E”lectronically shift controlled version of the 4L60. The Late 4L60-E was released in 1997 in and fully phased into wide use through GM by 1998 in both RWD car platforms (including the C6 Corvette) and trucks in both 2wd and 4wd configurations.
Is the 4L60E transmission bellhousing the same?
4L60E transmission bellhousings are not the same. One of the main differences in the earlier and later 4L60E transmissions is the bellhousing area. In the earlier versions, the case was cast as on piece of aluminum. In the later versions of it had a removable bellhousing.
Why is my transmission slipping on my 4L60E?
Something wrong with the transmission solenoid. Old, damaged, and worn gears. Broken or worn transmission bands. If you do experience transmission slipping problems with your 4L60E, and it’s not down to transmission fluid, then it’s time to visit the local mechanic.
Is the GM 4L60E transmission compatible with The TH700R4?
The input shaft and torque converter are now 300mm, which means that they are no longer compatible with each other. The 4L60E transmission is both the physical and spiritual successor to the TH700R4. It was the workhorse of the GM automatic transmissions at the turn of the century.
What kind of transmission is the 4L60E?
What is a 4L60E Transmission? The 4L60-E is an automatic shift, four-speed overdrive, longitudinally positioned transmission. It has been considered to be the best rendition of the finest overdrive automatic transmission ever produced.
How much fluid does a GM 4L60E need?
The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.
Can a 4L60E bellhousing be used on a Gen i engine?
The 4L60E bellhousing can bolt to either engine, although you may need an adapter to get a Gen III transmission to bolt to Gens I and II and vice versa. For the purposes of easy identification, we have broken the 4L60E into 4 distinct eras. These eras are easy to identify from the outside of the transmission.
How to change transmission on silveradosierra 4L60E truck?
Always jack truck up in NEUTRAL. Block the rear tires because you are going to remove the linkage bracket. Get ready to make a mess. Start removing the drain plug if you are lucky enough to have. It should be on the bottom of the pan a 15mm headed plug. Then start removing the front pan bolts. After that remove the side pan bolts.