How do you lubricate an ignition key lock?
Spray the lock cylinder with the lubricant. Be sure to hold the lubricant six to eight inches away from the cylinder so that the WD-40 does not all get sprayed into one spot. Insert the key into the lock and turn it in both directions to spread the lubricant over the cylinder.
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
How do you replace an ignition switch on a car?
Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.
Where is the release pin on an ignition switch?
The new or rebuilt switch should slide easily back into its hole on the steering column. Align the shape of the cylinder and the location of the release pin with the coinciding grooves in the ignition module.
Where can I get a Pontiac Grand Prix ignition switch?
Check out my gear head channel. All the videos here are power related, from lawn mowers, snow blowers and my ever expanding fleet of automobiles. I specialize in trash picked equipment and finding new life in them with other than intended purposes.
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
The new or rebuilt switch should slide easily back into its hole on the steering column. Align the shape of the cylinder and the location of the release pin with the coinciding grooves in the ignition module.