How long does it take for security light to turn off?
Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops
What should I do if my PassLock security light goes off?
If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine. If it starts and runs, everything is okay.
How to turn on security light without starting engine?
Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.
Why is my outdoor security light not turning off?
If your outdoor security light won’t turn off, it’s most likely because of one of these problems: The sensitivity settings are too high The duration settings are too high It’s stuck in auto mode
What should I do if my security lights wont turn off?
Simply cut off power to your security lights and leave the power off for a full 30 seconds. After then kick them back on. The light should run for a few minutes, maybe two or three, and then cut off and act normal from now on. If the problem persists, however, it’s probably time to call in an electrician.
What should I do if my PassLock light does not turn on?
2. Observe that the vehicle fails to start and the passlock security light is illuminated or flashing. 3. Release key to the ON/RUN position (not the ACC position or OFF) 4. Allow the vehicle to sit with key in the ON/RUN position for no less than 11 minutes. The passlock security icon should turn off after this.
How long does it take for motion lights to turn off?
Another common setting, duration for motion lights can range from five minutes to up to half an hour or more. Be sure your duration isn’t set too high before you make a costly repair call!
How do you reset a motion sensor light?
Turn the switch on and check your lights. If this does not work, proceed to step two. Step 2: Turn your light switch on and off quickly, hitting each position four times. When the light comes on, turn the switch to the off position and wait five to seven seconds before turning it on again.