How do you reset the service tire monitor on a Pontiac G6?
2008-2010 Pontiac G6: How To Reset TPMS Low Tire Pressure Light
- Turn the ignition key to the “ON” position without starting the engine.
- Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds.
- Activate the TPMS sensor.
What does SVC tire monitor mean on a Pontiac G6?
This system notifies you if the tire pressure is too low. When you get the Service Tire Monitor warning, it indicates that there is a problem with the tire monitoring system itself. Id does not mean that the tire pressure is (necessarily) too low.
Who is the owner of the Pontiac G6?
GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem, and the name G6 are registered trademarks of General Motors. This manual describes features that may or may not be on your specific vehicle either because they are options that you did not purchase or due to changes subsequent to the printing of this owner manual.
What to do if your GM airbag light is on?
If your dealer will not cover the repair, contact the GM customer service center. 1. Disable the airbag system. 2. Replace connectors on both driver and passenger seats. Then reroute and attach the harnesses to the seat using the service kit. 2. Disconnect connector C308 from driver’s seat cross-beam. 3. Remove the driver’s seat.
Can a GM airbag be replaced for free?
GM will replace the worn/defective connector parts for free as long as your vehicle VIN number is covered by the bulletin (see below for compatibility)
GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem, and the name G6 are registered trademarks of General Motors. This manual describes features that may or may not be on your specific vehicle either because they are options that you did not purchase or due to changes subsequent to the printing of this owner manual.
If your dealer will not cover the repair, contact the GM customer service center. 1. Disable the airbag system. 2. Replace connectors on both driver and passenger seats. Then reroute and attach the harnesses to the seat using the service kit. 2. Disconnect connector C308 from driver’s seat cross-beam. 3. Remove the driver’s seat.
GM will replace the worn/defective connector parts for free as long as your vehicle VIN number is covered by the bulletin (see below for compatibility)