Why do I have a problem with my Radio?

Why do I have a problem with my Radio?

It is often a process of elimination to find the cause. If the sound begins to burble or cut out altogether or you have lost a radio station it is probably due to one of the following: the signal has weakened due to a network fault or there’s a problem with your equipment or installation.

How to troubleshoot poor or no AM or FM radio reception on your car?

How to troubleshoot poor or no AM or FM radio reception on the car stereo. IMPORTANT: It is recommended that all car stereo installations be performed by a qualified, professional installer. NOTE: If model-specific information is needed to complete any of these steps, refer to the instructions supplied with the product.

What to do if your radio reception is poor?

If your radio reception is poor then you could consider an external aerial for best reception quality. Even in good areas an external aerial will guarantee optimum performance and will also ensure consistent listening quality.

Why does my DAB radio keep cutting out?

If the sound begins to burble or cut out altogether or you have lost a radio station it is probably due to one of the following: the signal has weakened due to a network fault or there’s a problem with your equipment or installation. By using our Transmitter Checker, you can check which DAB radio services are available at your location.

What should I do if my CB radio is not working?

Make sure the CB radio’s ground wire is connected to a good chassis ground in the vehicle. If your CB radio is not connected directly to the battery, make sure the fuse panel or extension wire it is connected to has a good connection to the battery. Make sure your vehicle’s electrical system is operating properly.

Why is my USB radio not working on my computer?

It has been narrowed down to the problem is within my computer. Other computers will program my radio fine. Strange, I can program other radios with my computer. But, for some reason my computer is not seeing my USB cable and / or radio. When I turn the radio on, the computer makes the little “doo-doo” sound.

Why does my computer make a doo doo sound when I Turn on the radio?

When I turn the radio on, the computer makes the little “doo-doo” sound. So far we have ran through every possible scenario we can think of. Different USB cables, different versions of software, different drivers, different USB ports. Tried letting my computer search the internet for a driver, all of those options produced no result.

Can a factory CD contain the correct driver?

The factory CD software that I received with the radio actually does contain THE correct driver. However, the driver was not loading onto my computer. I had to go in and manually load the driver onto my computer and then go in and manually tell the driver to “run”. Problem solved. Very quirky Chinese software.