How do you reset the anti theft system on a 2007 Pontiac g6?
Use the correct G6 key to restart your vehicle.
- Open the G6 door and insert your key into the ignition.
- Turn the ignition key to crank the engine.
- Listen to the engine as you try to crank it.
- Locate the engine compartment fuse box under the front hood near the engine block on the driver’s side.
How to clean the throttle of a Pontiac G6?
3. Clean the throttle body bore and the throttle valve plate using a clean shop towel with ETech Chemicals ET110 Throttle Body Cleaner. 4. Install the air intake duct. Refer to Air Cleaner Inlet Duct Replacement. 5. Perform the Throttle Learn Procedure.
What should the idle speed of a car be?
If the engine idle speed has not been learned the vehicle will need to be driven at speeds above 70 km/h (44 mph) with several decelerations and extended idles. 7. After the drive cycle, the engine should be idling normally.
What should the idle speed be on a Chevy Malibu?
Start and idle the engine in PARK for 3 minutes. 6. After the 3 minute run time the engine should be idling normal. Important: During the drive cycle the check engine light may come on with idle speed DTCs. If idle speed codes are set, clear codes so the ECM can continue to learn.
3. Clean the throttle body bore and the throttle valve plate using a clean shop towel with ETech Chemicals ET110 Throttle Body Cleaner. 4. Install the air intake duct. Refer to Air Cleaner Inlet Duct Replacement. 5. Perform the Throttle Learn Procedure.
What should the idle time be on a Chevy Malibu?
1. Start and idle the engine in PARK for 3 minutes. 2. With a scan tool, monitor desired and actual RPM. 3. The ECM will start to learn the new idle cells and Desired RPM should start to decrease. 4. Ignition OFF for 60 seconds. 5. Start and idle the engine in PARK for 3 minutes. 6. After the 3 minute run time the engine should be idling normal.
If the engine idle speed has not been learned the vehicle will need to be driven at speeds above 70 km/h (44 mph) with several decelerations and extended idles. 7. After the drive cycle, the engine should be idling normally.