Why is my Montana engine cranking but not starting?
There are a lot of issues that can cause your Montana to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.
Are there any problems with the 2008 Montana?
Help? Loading Curious how the 2008 Montana compares to other years? Check out our Pontiac Montana overview to see the most problematic years, worst problems and most recently reported complaints with the Montana.
Why does my GM car say no start no crank?
How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.
Why does my car not have enough fuel?
Other possible causes of your lack of fuel issue could be the fuel injectors or an electrical problem. If the fuel injector fuse(s) are blown due to a wiring issue, this may cause your problem.
What should I do if my fuel pump is not working?
A clicking noise can be heard from each injector when they are working properly. I would recommend having a technician from YourMechanic try to start your vehicle with starter fluid. This should give the engine enough fuel to run long enough to see if the injectors are working correctly.
Why does my car engine not want to start?
If the engine still doesn’t seem like it wants to start, probably fuel is getting into the cylinders and your problems lies somewhere else. However, if the engine runs momentarily and dies, then the problem is that fuel is not getting to the cylinders. Check for a clogged fuel filter, or a bad fuel pressure regulator.
Why does my Car start after I fill up the gas tank?
When I fill the gas tank up, the car has trouble starting. It happened several times already. I would then try for a while until I start it up again. After that, the car would run fine until I fill the gas tank up the following time. I went to a shop for this but they couldn’t fix it. Do you have any idea why this happens? Thank you.
What to do if your car won’t start after filling up?
If you are getting random misfire codes and O2 sensor codes after getting fuel i suggest you have a fuel sample test to see if there is excessive water in the fuel. You can try adding some drygas in the… It is a given that when you take your car to a mechanic for a noise, it will stop making the noise right when he gets in the car.
There are a lot of issues that can cause your Montana to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.
What to do when your car won’t start?
You can help your car start by holding the throttle wide open to get extra air into the engine to get it started, and then letting off the gas once it starts. This is only a way to get it started after refueling until you get the purge valve replaced to fix the problem.
When I fill the gas tank up, the car has trouble starting. It happened several times already. I would then try for a while until I start it up again. After that, the car would run fine until I fill the gas tank up the following time. I went to a shop for this but they couldn’t fix it. Do you have any idea why this happens? Thank you.
What happens when there is no spark in the engine?
When there is no spark, the engine will not start. You’ll probably have a misfire related code such as P0300, P0301, etc….. Ignition issues can be caused by many things, including bad spark plugs, bad coil packs, bad plug wires, computer issues, and more.
Where is the fuel pump relay on a Pontiac Grand Am?
The fuel pump relay is #18 in the fuse box. Start with the car off, and have somebody else put the key in the cars ignition and attempt to start the car while you listen to the relay. If you can hear this relay make a “clicking” noise as the car attempts to start, then it is working properly.
Why is the starter not turning on my Pontiac Grand Am?
If you can hear the starter motor turning but the engine isn’t turning (look at the belt) then the starter may not be engaging (in your car I believe this means that you must replace the whole starter). You can remove and test your starter to confirm whether or not the solenoid is engaging the starter.
When does your state have to shut down again?
That threshold is based on data regarding when states imposed their first mandates in March and April, and assumes that many states will have to reimpose similar mandates. Based on that metric, read on to see if your state is one of the 22 that may have to shut down again in the coming months.
What causes a riding lawn mower to not start?
7 Simple Reasons Your Mower Won’t Start 1) Out of Gas 2) Stale Gas Leads to Clogged Carburetor 3) Clogged Fuel Filter 4) Dead battery 5) Bad Starter Solenoid 6) Disconnected or Dirty Spark Plug 7) Dirty Air Filter
Is there a way to turn off auto stop start?
Opinions on engine auto-stop-start technology are scattershot: some enjoy the technology and its attempt to increase fuel efficiency, some are indifferent, and the rest downright hate the feature and will go to great lengths to turn the system off at every opportunity, especially in vehicles that don’t offer a way to disable the feature.
What to do if your car starter won’t engage?
The battery powers the starter, and if it is not working, the starter will fail to engage completely. Charge your car battery fully, and you can even try to replace the car battery if you have another one you know works.
Why does my car not start with jumper cables?
If they are damaged or corroded badly, they can prevent proper amperage draw for the starter. Since you said it starts with jumper cables, it is most likely a bad battery. As CharlieRB pointed out, just because the lights come on doesn’t mean the battery is ok.