Why does my Mazda 323 have a flashing orange hold light?

Why does my Mazda 323 have a flashing orange hold light?

Recently my car’s dash has been displaying a flashing orange “HOLD”. It doesn’t happen all the time (twice in the last 2 or 3 weeks that I can think of) and the length of time it stays on for varies as well. I’ve checked Google for a bit of info, and I understand its a problem with the transmission, though I can’t get much more than that.

Why is there no spark on my Mazda 323?

If there is no spark, it is probably the distributo that has gone faulty. Check your local Mazda Dealer. Cosmo. Mazda Tech helpful? Could be the coil check its primary and secondary resistances and to include power at the pos. Terminal of the coil while key is in On position- could also be one of those that Mr. Cosmo mentioned. helpful?

What should the resistance be on a Mazda 323?

The resistance reading between the two pins in the electrical connector should be around 250 ohms – mine was open circuit (‘infinite’). Mazda part number is FN01-21-550 and I got mine on eBay.

Where is the hold button on a Mazda 323?

The “Hold” you are referring to is in regard to the Overdrive/top gear lockout. The button located on your gear lever just below the “T” This button is for holding 3rd gear when going up steep hills etc. I just verified this with our Astina. So, it’s probably just a loose wire. Hopefully! Good Luck!

What makes a Mazda 323 se not start?

No spark. Changed ignition coil, distributor cap and rotor. 1992 mazda 323 believe engine is a 1989 Mazda 323 SE Car will not start. No spark. Changed ignition… I have a Mazda 121-88 which will not start. No spark. I Hi. I have a Mazda 121-88 which will not start. No spark. I changed distributor cap and rotor. No difference.

Why does the at warning light come on on my Mazda 3?

AT warning light would come on and my car would jerk as if shifting gears and I have an automatic (Mazda 3). Yesterday took to the dealer and did a diagnostic. I had to replace the two speed sensor and did a transmission flush as that was also causing the AT light to turn on. This is what the dealer told me.

What does a t light mean on a Mazda Premacy?

If a t light on mean transmission overheating need a flush and filter change usually over heat cause filter clogged if u in Pennsylvania ,Newjersy or deware try the mobile mechanic they come to you call 2674071967 37 people found this helpful.

Posted In Q&A