How to change the rear brakes on a Pontiac Grand Prix?
A turkey baster is a good tool for this. Put the brake fluid in the plastic container and dispose of it the way you dispose of motor oil. Raise the rear end of your car with your car jack. Remove the rear tire or wheel assembly. Remove the parking brake cable from the back of the caliper.
How do you replace the struts on a Pontiac Montana?
Jack up the front of your Pontiac Montana using a floor jack and place a jack stand under the vehicle frame to support it. Finish removing the tire. Remove the three mounting nuts from the wiper module on top of the strut tower you want to replace and lay the module out of the way.
How do you remove a strut from a car?
Use a pencil or correction fluid. Unbolt the two strut lower bolts and nuts from the strut-to-steering knuckle bracket. Hold the bolt steady with a wrench as you unscrew the nut with a wrench or ratchet and deep socket. Remove the strut assembly from the vehicle.
A turkey baster is a good tool for this. Put the brake fluid in the plastic container and dispose of it the way you dispose of motor oil. Raise the rear end of your car with your car jack. Remove the rear tire or wheel assembly. Remove the parking brake cable from the back of the caliper.
How do you replace a rear brake caliper?
When the rear calipers start to fail, they will need to be removed and either rebuilt or replaced. Part of the removal process is taking off the emergency brake cable, which should take about 15 minutes per side to do. Lift the rear end of the vehicle using a jack then place it on jack stands.
Where is the emergency brake cable on a caliper?
Look around the backside of the caliper to find the emergency brake cable connection, which will go through a large spring and hook onto a bracket. Pry the ring on the end of the emergency brake cable off of the hook on the bracket using a flat head screwdriver.
When did I replace my front brake pads?
My 2001 Pontiac Grand Prix GTP is about to hit the 91,000 miles mark on the odometer. The rear brake pads are the originals and the front brake pads were replaced during the 60,000 mile service.
What kind of brake fluid does a Grand Prix use?
You can use either DOT 3 or DOT 4 fluid which are both glycol based. Do not use DOT 5 brake fluid, which is silicon based and is not compatible with the 97-03 Grand Prix braking system. Next I removed the plastic lug nut caps with a 19mm socket and loosened the lug nuts with the lug wrench.
Do you need a caliper Rotation tool for disc brakes?
Other brake kits designed for use on vehicles with disc brake systems include a variety of caliper adapters and a caliper rotation tool. If you are working on a car or truck that has drum brakes, you may want to consider an all-in-one kit that contains all of the parts necessary to complete a brake job.
Is it OK to compress rear brake caliper?
Brake Caliper Piston Compressor Windback. This is what should be used: http://amzn.to/2ECIIWW It is not recommended that you compress a wind back caliper in this fashion and you run the risk of damaging the rubber boot or damaging the brake caliper piston. I only recommend using this method if you are in a jam.
What kind of tools are used for disc brakes?
Specialized tools, such as equipment for bleeding brakes, may be available as a complete kit. Other brake kits designed for use on vehicles with disc brake systems include a variety of caliper adapters and a caliper rotation tool.