What does the P0420 code on a Peugeot mean?
P0420 Combinations of P0420 or 0420 indicate a malfunction in the catalytic converter. The problem is to reduce the efficiency of the device, which can lead to malfunctions in the power unit. To solve the malfunction, the unit should be diagnosed and repaired or replaced.
What is the fault code for a Peugeot 3?
P0200 Code P0200 is general and indicates a malfunction in the wiring of the power unit injector P0203 Open circuit of the injector control system of the third engine cylinder P0204 In the error catalog, code P0204 indicates an open circuit in the operation of the injector control system in the fourth cylinder
What does the P0300 code on a Peugeot mean?
P0299 Malfunction in boost pressure control system – operating parameter too low P0300 Codes P0300 or 0300 indicate a moving problem associated with a malfunction in the engine cylinders. The engine cylinder number is not indicated, so the user will have to find it on their own.
What does the p0094 code on a Peugeot mean?
P0094 If this code appears on the panel, this indicates a malfunction of the pressure limiter located in the fuel rail. The cause of the problem may be the high pressure fuel pump and injectors. First, it is recommended to check the wiring through which the pressure sensor is connected.
What does DTC p0230 mean on a fuel pump?
The ECM monitors the fuel pump relay circuit for voltage. If voltage malfunctions, it will set DTC P0230, which is defined as “Fuel Pump Relay – Circuit Malfunction.” “Circuit Malfunction” indicates that there is a malfunction in the control circuit, as opposed to a fault in a sensor or other component.
What causes the p0230 OBD-II trouble code?
P0230 is a generic OBD-II code which indicates that the fuel pump primary circuit has a malfunction of the vehicle power to the fuel pump when it is commanded on or off What causes the P0230 code? The engine control module (ECM) detects the primary fuel pump circuit voltage as below specifications from the fuel pump relay to the ECM
What is the diagnostic code for fuel pump?
P0230 is a diagnostic trouble code (DTC) for “Fuel Pump Primary Circuit Malfunction”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What happens if the fuel pump relay is faulty?
Relay – If the fuel pump relay is faulty, no voltage will go to the fuel pump or monitor. Harness Damage – If there is damage to the harness going to the fuel pump, it can cause excessive resistance (corrosion), an open circuit (broken wire), an intermittent open circuit (partly-broken wire), or a short to ground (contacting the body or chassis).