What is the ABS warning light on a Peugeot 407?
If your brake fluid is correct you may need to take your Megane to the nearest Peugeot workshop. This light can be accompanied by the ABS warning light (See above) if the Peugeot 407 has an ABS fault. You can diagnose the problem yourself by using the iCarsoft CP V1.0 Peugeot OBD Code Reader kit.
How to reset the Mercedes Benz ESP warning light?
Replacing the ABS sensor is easy, you can learn how to replace ABS sensor here. Note that once you will replace the ABS sensor and will still have the ESP warning light on. You will need to follow the procedures below to reset the light.
Can a faulty ABS sensor cause the ESP system to be disabled?
Because the ESP system depends on the ABS system to function properly, the ESP system will also get disabled. A faulty ABS sensor could cause other issues as well such as Check Engine Light, car not moving when in Drive, speedometer not working.
Is there a reset tool for Peugeot 407 airbag system?
We advise you to use a reset tool that covers the Peugeot 407 airbag system such as the iCarsoft CP V1.0 Peugeot OBD Code Reader. Once the problem has been found and has been corrected, the airbag light can be removed from the dashboard of your Peugeot 407. Peugeot 407 ABS warning light – indicates a problem with the ABS system.
What is the ABS and ESP warning light on my Peugeot 407?
I have a 56 reg, Peugeot 407 2.0 hdi auto and recently the ABS & ESP warning lights apoear every time the ignition is switched on. This has happened before on an intermittent basis then nothing showed for over a month before this more permanent episode.
Is there an ABS sensor fault on a 407?
With the abs sensors costing around �130 each (not including labour) this repair could end up costing �600+ and still not fix the fault. So, to the point of my post. I have noticed through a quick scan of this and other forums that abs / esp sensor faults are fairly common in 407’s and even 307’s.
How much does it cost to fix ABS on a Peugeot 407?
They managed to reset the ecu so that the speedo began working again but this only lasted a few days. With the abs sensors costing around �130 each (not including labour) this repair could end up costing �600+ and still not fix the fault. So, to the point of my post.
What does the p code on the ABS light mean?
If the abs/traction lights are showing, there must be some fault logged in the system , even if the problem is intermittent. “P” codes are for Powertrain engine/ transmission.