What kind of oil pump does DT 466 engine use?
This video is all about a repair our shop did on a DT466E International diesel engine. It would not start and we finally found the engine oil pump to be weak along with a scored oil pressure regulator. The engine oil pump feeds the ‘high pressure oil pump’ that runs the HEUI system.
Why does my dt466e have no oil pressure?
Pulled the tube and checked it. It was fine. Pulled the engine oil pump (on crank) and it looks worn. Light grooving and some wear on the gear lobes in the pump. Leaning towards that being it. With it not filling the front cover i don’t think it’s the pressure Reg but i could be wrong.
How is a high pressure oil pump disassembled?
High-Pressure Oil Injection system High Pressure Oil Pump disassembly photos. This 2001 DT466Edigested a Babbitt bearing that used to be in contact with the crankshaft. Engine was fully disassembled and rebuilt, but still would not fire.
Is the International diesel high pressure oil pump kit 1825685c1?
In addition, Raney’s will not be liable for any incidental or consequential damages and your exclusive remedy shall be replacement of the product that did not comply with this limited warranty. Click the button below to add the International Diesel High Pressure Oil Pump Kit 1825685C1 1842906C92 to your wish list.
This video is all about a repair our shop did on a DT466E International diesel engine. It would not start and we finally found the engine oil pump to be weak along with a scored oil pressure regulator. The engine oil pump feeds the ‘high pressure oil pump’ that runs the HEUI system.
Why is my DT 466E engine not working?
The bus in question was a 1998 International conventional with a DT 466E diesel engine. It was the middle of winter so the cold temperature was a contributing factor with the no start situation. We went out to have a look and could not get it going so the next step was to tow it in and have a closer look.
In addition, Raney’s will not be liable for any incidental or consequential damages and your exclusive remedy shall be replacement of the product that did not comply with this limited warranty. Click the button below to add the International Diesel High Pressure Oil Pump Kit 1825685C1 1842906C92 to your wish list.
What kind of oil pump runs the HEUI?
The engine oil pump feeds the ‘high pressure oil pump’ that runs the HEUI system. This solved the no start problem. Upload, livestream, and create your own videos, all in HD.
Pulled the tube and checked it. It was fine. Pulled the engine oil pump (on crank) and it looks worn. Light grooving and some wear on the gear lobes in the pump. Leaning towards that being it. With it not filling the front cover i don’t think it’s the pressure Reg but i could be wrong.
What should I read on oil rail, dt466e?
I have a DT466E with low ICP pressure. New IPR valve, new HPOP, all 6 new injectors, still low ICP. Pulled new HPOP off and had it bench tested, … read more Vocational, Technical or Tra… I have a 2005 international 4300. I have changed the Hi Andy I have a 2005 international 4300.
Is the dt466e a 2001 International Truck?
The Hi, I have a 2001 international truck with the DT466E. The truck was pulling hard up a hill when the warn/engine light came on and it lost power. It has codes 333 and 335. It starts with a wiff of eit … read more
Why is my DT466 diesel not getting fuel?
Pump shaft seals can leak and let air in pump and fuel in crankcase. Normally that creates a cold start problem after setting a while and a crankcase full of fuel when running. Normally dying while running is a problem between the injection pump and tank.
Where is the ferry plug on a DT466?
A DT466 high pressure oil pump leak is one of the most common issues found on these International engines. While there are a few reasons a high pressure oil pump (HPOP) could leak oil, the most common issue is it to leak past the threads and O ring on the ferry plug, found on the back of the HPOP facing the engine block.
Where is the lift pump on a DT466?
No, the lift pump is mounted to the HPOP about 1/2 way up the left side of the engine rear face of the gear cover (just above the air compressor, if it has one). Did you find the recommended reading relevant to this discussion?
Why do I have oil pressure problem on my DT466?
Some of the fault codes you have could be from problems that were repaired long ago and no one bothered to clear them. to the injector harness is a problem area on a DT466E. It wears from vibration and can cause a lot of problems. I have seen the connector wear enough to fall off of it’s mating connector and the engine die in the middle of nowhere.
Can a HPOP be used on a DT466?
This article applies to all DT466 engines equipped with a HPOP, however specifics such as wrench or socket size could be different from engine to engine. The engine this article is based off of was found in a 2000 International 4700 DT466E. For other International specific guides, visit the International category page.