What oil does a Cadillac Deville take?

What oil does a Cadillac Deville take?

Engine Oil

Viscosity: 10W-30 (Above -18) 5W-30 (All TEMPS) SAE 5W-30 is preferred.
Capacity: 7.5 quarts (with filter)After refill check oil level.
Torque: 15 ft/lbs (Oil Drain Plug)

What kind of oil goes in a 99 Cadillac DeVille?

Engine Oil SAE 10W-30 is preferred. Capacity: 7.5 quarts (with filter)After refill check oil level.

What oil does a 1993 Cadillac DeVille use?

Engine Oil

Viscosity: 10W-30 (Above -18) SAE 10W-30 is preferred. 30 (Above 4) Use only if the other recommended viscosities are not available. 5W-30 (Below 16)
Capacity: 5.5 quarts (with filter)After refill check oil level.
Torque: 22 ft/lbs (Oil Drain Plug)

What kind of motor oil should I use for a 1970 Cadillac?

What would be the best conventional motor oil we should be using for our 1970-1979 Cadillacs with 492/500 cu engines. There seems to be a lot of concern with the amount of zinc additives that the manufacturers put into these oils.

What was the length of a 1979 Cadillac DeVille?

The 1979 Cadillac DeVille measures 76.48 inches in width, The 1979 Cadillac DeVille measures 221.20 inches in length, and has a wheelbase of 121.50 inches. Vehicles with Similar Dimensions.

What kind of oil do you use in a caddy?

73 caddy oil.png (185.7 kB, 651×366 – viewed 591 times.) I have run 20W/50 and 15W/50 , full SYNTHETIC oils in my 472/500 Cadillacs , and 460 Ford vans for many years , and hundreds of thousands of miles.

How many horsepower does a Cadillac DeVille have?

Displacement : 6965 cc | 425.0 cu in. | 7.0 L. Power : 180 HP (132.48 KW) @ 4400 RPM Torque : 320 Ft-Lbs (434 NM) @ 2000 RPM Bore : 4.1 in | 104 mm. Stroke : 4.1 in | 103 mm.

What would be the best conventional motor oil we should be using for our 1970-1979 Cadillacs with 492/500 cu engines. There seems to be a lot of concern with the amount of zinc additives that the manufacturers put into these oils.

What kind of engine does a Cadillac Brougham have?

From 1986 to 1990, the rear-wheel drive Cadillac Brougham used a carbureted 307 cu in (5.0 L) Oldsmobile V8 (replacing the Cadillac HT-4100). In 1990 a 175 hp (130 kW), fuel-injected small-block 350 cu in (5.7 L) Chevrolet L05 V8 (became a Regular Production Option (RPO) when the towing package was selected.

What kind of engine does a Cadillac Seville have?

While initially the Cadillac Seville for example, which was positioned in the mid sized segment used a variant of 350 cu in (5.7 L) Oldsmobile based architecture V8, Cadillac also began work on its own proprietary engines.

What kind of engine did Cadillac have in 1928?

Cadillac created a new V8, the 341, for 1928. It was a 341 cu in (5.6 L) engine and produced 90 hp (67 kW). The same year saw the introduction of the synchromesh transmission. This engine was used in the Series 341 and 341B cars of 1928 and 1929.