What oil does a 2003 Yamaha Blaster take?
The Right Synthetic Motor Oil for Your 2003 Yamaha Blaster AMSOIL synthetic lubricants are the solution for riders who want the most from their 2003 Yamaha Blaster. They resist extreme heat and stress from aggressive riding or hard work, even in temperature extremes.
How do you check the oil level on a Yamaha Blaster?
Transmission oil
- Place the machine on a level place.
- Warm up the engine for several minutes, and stop it.
- Check the oil level through the level win- dow located at the right side crankcase. cover. NOTE: Wait a few minutes until the oil level settles. before checking.
- The oil level should be between the maxi-
What kind of gear oil does a Yamaha Blaster take?
ATF or gear oil or ideally a specialty motorcyle oil designed for 2-stroke gearboxes like Motul Transoil 10w30. For wet clutches thinner is better, and synthetic has some issues. Do NOT use 10w30 motor oil, especially if it says: “Energy Saving”.
What kind of oil do you put in a Yamaha motorcycle?
JASO MA = Oil for motorcycles with wet clutches. SG = An oil rating. Choose an oil that is SG or higher, ie SH, SM etc, but not SD for example. Ext Tank = Eternal Oil Tank, not Premix. AEROX RACE REP.
What kind of oil should I use on my Aprilia motorcycle?
Your ideal choice of oil would be an ester semi-synthetic 10W-40 or a 10W-30 that is also shear-stable. The fact that the oil is shear-stable is more important than the fact that it is semi-synthetic. You are still better off choosing shear-stable mineral-based oil than a low-quality semi-synthetic one that isn’t shear-stable.
What kind of oil do I need for a marine engine?
Marine engine oils are so different in their requirements that special levels of certification exist: FC-W ® (four stroke) and TC-W3 ® (two stroke). These represent the minimum standards of the National Marine Manufacturer’s Association (NMMA®) for marine engines.
ATF or gear oil or ideally a specialty motorcyle oil designed for 2-stroke gearboxes like Motul Transoil 10w30. For wet clutches thinner is better, and synthetic has some issues. Do NOT use 10w30 motor oil, especially if it says: “Energy Saving”.
What kind of oil should I put in my Blaster?
As for pre-mix oils I always recommend a semi-synthetic castor based oil such as the factory yamalube 2R or Klotz R50. I’ve found that the full synthetics don’t burn off as well and therefore leave deposits/film which over time can gum rings and restrict the exhaust port.
What kind of oil do you put in an engine?
It takes transmission oil and you premix for engine. I recommend using ATF (auto trans fluid) but it has to be TYPE F or FA. Then for engine oil, use bel ray, klotz, amsoil, or any high end oil for premix. I prefer running 32:1 because your top- end lasts longer than leaning it out. Then use premium gas to mix the engine oil with.
JASO MA = Oil for motorcycles with wet clutches. SG = An oil rating. Choose an oil that is SG or higher, ie SH, SM etc, but not SD for example. Ext Tank = Eternal Oil Tank, not Premix. AEROX RACE REP.