How do you drain fluid from a Ford Ranger?
*lf a suction gun is used to drain the fluid, remove the fill plug and insert the suction tube into the fill hole until it rests at the lowest most point inside the housing. Operate the suction gun as per the manufacturers directions. When the fluid is completely removed, skip to the differential filling procedure.
Where is the fluid filler plug on a Ford Ranger?
Like the manual transmission which is available, the rear axle does not have a dipstick to check fluid level. Instead, a filler plug is located in the side of the housing (or in the side of the cover), at a level just barely above the level to which fluid should fill the housing. To Check The Fluid Level:
How do you change the oil in a Ford Ranger?
For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Ranger oil filter wrench. If your Ranger is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Ranger.
What kind of lubricant do you use on a 1998 Ford Ranger?
Refill the drive axle housing using the proper grade and quantity of lubricant. Install the filler plug, operate the vehicle and check for any leaks. The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models.
For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Ranger oil filter wrench. If your Ranger is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Ranger.
How much fluid does a Ford Ranger need?
Need to know what type of fluid your Ford Ranger needs? 3.0 quarts (drain and refill) / 6.0 quarts with torque converter drain. Add more fluid as needed, 1/2 pint at a time. 3.0 quarts (drain and refill) / 6.0 quarts with torque converterdrain. Add more fluid as needed, 1/2 pint at a time.
How to change automatic transmission fluid in Ford Ranger?
Discard the old pan gasket. 6. If necessary, remove the Automatic Transmission Fluid (ATF) filter mounting bolts, then remove the filter by pulling it down and off of the valve body. Make sure any gaskets or seals are removed with the old filter. The transmission usually has one round seal and a rectangular gasket.
What’s the size of an oil drain plug?
1992-88 2.5L m85 x 2.50 . 1987 2.5L Calais MT m85 x 2.50. Alldatadiy.com and Eautorepair.net are professional-grade shop manuals—period. They include wiring diagrams and technical service bulletins.