How do you test a Honda ignition switch?
To begin testing your ignition switch, go ahead and crank down the steering column to it’s lowest point. Slide the driver seat as far back as it will go, to give you plenty of room to operate. You will be removing the steering column cover to expose the switch, your ignition tumbler and the wiring connector.
What do you need to know about Honda Civic ignition switch?
There are a few parts of the electrical system that work without the key at all for safety reasons, such as the headlights, brake lights, horn, and dome light. Things such as the power windows (but not power locks), sunroof, radio, rear defrost, and climate control are all going to depend on the ignition switch for power.
How do you test the ignition switch on a Honda Accord?
To test the ignition switch: Unplug the ignition switch’s 6 pin connector from the driver-side fuse/relay box. Place your multimeter in Ohms mode. Using the illustration below: Your multimeter should register continuity between. LOCK position: NO CONTINUITY between any terminal.
What are the symptoms of a bad ignition switch?
Symptoms Of A Bad Ignition Switch. Honda Accord Ignition Switch Test Basics. Testing the 1998-2002 Honda Accord Switch. Save Money On Your Honda Accord’s Ignition Switch. More Honda 2.2L, 2.3L Tutorials.
How do you test the ignition switch on a car?
In a nutshell, testing the ignition switch involves checking the continuity of certain terminals, of the ignition switch’s connector, while the key is in certain positions. Contents of this tutorial: Symptoms Of A Bad Ignition Switch.
When do you Know Your Honda Civic ignition switch is bad?
If your Honda Civic is starting right up, but then immediately dies, that is a very good indication that the ignition switch is bad. Here’s what happens. You aren’t getting power to the ignition or fuel pump while the key “rests” in the run position. But, you are getting it when the starter is engaged.
How do you replace Ignition Control Module on Honda Civic?
Remove two Phillips screws underneath the ICM to replace it. Simply install the new ICM with the same screws. Reattach the wires connecting the ICM to the distributor housing. Reattach the inner cover and rotor. Secure the rotor with the Phillips screw. Reattach and secure the distributor cap.
To test the ignition switch: Unplug the ignition switch’s 6 pin connector from the driver-side fuse/relay box. Place your multimeter in Ohms mode. Using the illustration below: Your multimeter should register continuity between. LOCK position: NO CONTINUITY between any terminal.
Symptoms Of A Bad Ignition Switch. Honda Accord Ignition Switch Test Basics. Testing the 1998-2002 Honda Accord Switch. Save Money On Your Honda Accord’s Ignition Switch. More Honda 2.2L, 2.3L Tutorials.