How do you reassembly a Kenmore tension Assembly?
Reassembly begins with orienting the take up spring on the post, and reinstalling it in the tension assembly body cup. Look at the picture closely, the spring has a hook on the coil end. This hook engages in one of the small slots in the post end.
How do you remove a motor mount from a car?
Remove the two motor mount bolts on either side of the engine and lift the engine free. Remove the bell housing bolts that secure the engine to the transmission. Support the transmission oil pan with a cinder block and pull the engine upward and forward. Remove the bolts that secure the flex plate to the crankshaft and remove the flex plate.
How do you install a rear main seal on a Ford 302?
Support the transmission oil pan with a cinder block and pull the engine upward and forward. Remove the bolts that secure the flex plate to the crankshaft and remove the flex plate. Remove the transmission’s shift lever dust boot and unbolt the shifter from the transmission housing, if your car has a manual transmission.
What should I do if my Dremel motor grinds?
Reattach the rubber spacer to the rear bearing and place the motor into the housing. Place the other half of the housing in place and test that to motor freely spins, if it grinds, open the case and flip the magnet assembly of the motor over and re-install, it should be smooth now. Screw the case shut.
How long does it take to replace a rear main seal?
However, the process to get to the rear main seal to replace it often requires removal of the entire engine and transmission from the vehicle, a job that can only be done by very skilled mechanics and even then can take 6-10 hours!
How to tell if your rear main seal is leaking?
One rear main seal leak symptoms is oil stains. Source: Shutterstock How to tell if rear main seal is leaking? The main symptom of a rear main seal leak is when your car starts leaving black stains on your driveway or parking lot.
How do you install ring on small block Ford?
You may roll the rings onto the piston by locking one end of the ring in the groove and walking the ring around into place. Take extra care not to scratch the ring lands. Here we’re using a piston ring expander to install the ring. All connecting-rod nuts are removed at this time.
Can a split seal be replaced on an engine?
To replace the seal, either the engine or transmission will have to be removed. Once one of those is removed, the oil pan also has to come out too, so this maintenance job is extremely labour intensive. The majority of older vehicle models use the rope or wick seal, with a small number using the split seals.