How do you connect battery cable to alternator?
Connect B+ battery cable to alternator. Turn on battery switch. Install a jumper from pin F in harness plug to B+ terminal on alternator. Note: the alternator charge wire routes direct to the battery and not through any switch connection, the alternator will not operate correctly if not connected direct to battery or directly through the ammeter.
Where to connect alternator voltage sensing wire-page 1?
The sense wire is used to account for the voltage drop between alternator and battery to ensure an accurate charging voltage, i.e. it should be connected to a point which is most representative of battery voltage.
Can a relay be connected to an alternator?
If there is already a charge indication lamp installed in your system, or you feel you need to install one, you could connect it as shown in fig. 2. Use a small relay and indication lamp which have the same voltage as the alternator.
How is the alternator connected to the engine?
Along with the battery, the alternator produces the electrical power needed to operate both the electrical components and engine of a vehicle. Alternators are mounted to the engine and are operated by a serpentine belt or powered by the crankshaft directly.
Connect B+ battery cable to alternator. Turn on battery switch. Install a jumper from pin F in harness plug to B+ terminal on alternator. Note: the alternator charge wire routes direct to the battery and not through any switch connection, the alternator will not operate correctly if not connected direct to battery or directly through the ammeter.
If there is already a charge indication lamp installed in your system, or you feel you need to install one, you could connect it as shown in fig. 2. Use a small relay and indication lamp which have the same voltage as the alternator.
Where is the output wire on an alternator?
P terminal. IGN terminal. Figure 1. For more information on charging the battery, refer to Routine Maintenance. Detach the output wire from the B+ terminal on the alternator. Attach a jumper wire from the EVR wiring harness connector green wire (outside terminal) to.
Do you have to disconnect the B + at the alternator?
You have to disconnect the 8pin connector on top the starter bracket as its part of the harness shown in the picture. disconnect the b+ at the alternator with 13mm disconnect the alternator signal connector and ac.Alternator WiringAlternator Terminals Explained | JAS Oceania | Auto Electrical Products
Do you need to upgrade the wire for an alternator?
Any time you upgrade your alternator, you should also strongly consider upgrading the gauge (size) of the wire that charges the battery as well as the fusible link in case of a short. The chart below charts the gauge wire required based on alternator amperage output and length of wire.