How big of a nut do I need to change my rear brake?
This large nut is usually a 22 or 24 millimeter metric socket, or a 7/8” standard socket. Use a breaker bar or half inch drive ratchet to turn the nut counterclockwise in order to remove it. A traditional 3/8-inch drive socket wrench may not allow you to put enough pressure on the nut to break it loose.
How do you remove a brake drum from a car?
Removing Brake Drums Jack the vehicle up and remove the wheel. Remove the dust cap with a screwdriver. Use a ratchet to unscrew the axle bearing nut. Twist the drum as you pull it backward to remove it. Spray the drum with rust remover if it’s stuck.
How do you change the brake pads on a car?
Pull the brake shoe set free from the backing plate. Grip the brake pads on either side and pull them directly toward you to separate them from the backing plate. The springs will come with the brake shoe set, but the parking brake cable should remain with the vehicle.
What’s the best way to change rear brake shoes?
Park the vehicle on a firm, level surface. Use a tire iron or the appropriate socket to loosen the lug nuts on the first rear wheel, then slide a jack beneath one of the vehicle’s rear designated jack points to lift the vehicle up. Always use jack stands when working on a jacked up vehicle. Unscrew the lug nuts and remove the wheel.
How to convert your old front drum brakes to newer disc brakes?
How to Convert Your Old Front Drum Brakes to Newer Disc Brakes 1. Park the car on a flat and level surface like that of your garage. Block the rear wheels and loosen the front lug… 2. Place the jack stands under the frame on both sides of the car behind the front wheels and carefully lower the
Can a bad conversion kit cause disc brakes to fail?
A lot of the companies selling disc brake conversion kits don’t test every single fitment. This is less of an issue on newer vehicles, but is a pretty common problem on older vehicles. A poor-fitting disc brake conversion kit can lead to serious problems down the road, such as brake system failure.
What kind of cable is needed for rear disc brake conversion?
Some vehicles have original equipment cables that can simply be converted from the attachment on the brake drums to what is required on the new conversion. Some situations, however, will require a completely new cable and approach.
Can a lugnut4x4 be used as a disc brake conversion kit?
As long as you’re installing one of our disc brake conversion kits on an original vehicle application (meaning it’s not an axle swap), the existing brake system will work just fine. When you buy a Lugnut4x4 disc brake conversion kit to upgrade your original drum brakes, we send you everything you need (except the brake fluid). 1. Poor Fitment