When should you replace power steering belt?
Most belts are designed to last between 60,000 and 100,000 miles. However, yours should be inspected at every single maintenance interval (every oil change). This ensures that you’re able to keep an eye on the belt’s condition and catch it before it fails.
Can a bad belt cause a power steering failure?
If you think your power steering failure is a result of a bad belt, here are some steps to help you through the replacement process. To successfully replace a power steering belt, getting the right type of belt is crucial.
Where is the power steering drive belt located?
The belt that drives a power-steering hydraulic-fluid pump is usually at the front of the engine , turned by a pulley on the crankshaft . It is generally separate from the belt that drives the water pump and alternator , but it may drive other components as well as the power-steering pump .
How to change the belt on a power steering pump?
How to Change a Power Steering Belt Step 1 – Get the Right Belt Step 2 – Unbolt the Steering Pump Step 3 – Remove the Old Power Steering Belt Step 4 – Replace the Old Power Steering Belt Step 5 – Replace the Bolts Step 6 – Apply Belt Dressing Step 7 – Check the New Power Steering Belt Topics:
How to check the tension on a power steering belt?
To check the tension, lay a straight-edge along the outer edge of the belt. If the belt goes round more than two pulleys, use the longest run of the belt. Use your thumbs to push the belt inwards at its mid point, pushing quite hard.
How do you remove a power steering belt?
Slacken the adjuster and pivot bolts, and push the pump inwards by the cast front plate until the belt is slack enough to ease off. Do not push against any other part of the pump or pipework, or you may damage it. Remove the old belt. If it is the outermost of several belts on the engine, removal is straightforward.
What to do if your power steering belt is too slack?
If the belt was too slack, increase the tension by levering the pump outwards with a strong screwdriver or flat bar. Lever against the cast front end of the pump body, just behind the drive-belt pulley — not against any other part of the body or pipework, which are easily damaged.
To check the tension, lay a straight-edge along the outer edge of the belt. If the belt goes round more than two pulleys, use the longest run of the belt. Use your thumbs to push the belt inwards at its mid point, pushing quite hard.
Where is the power steering pulley located on a car?
Lever against the cast front end of the pump body, just behind the drive-belt pulley — not against any other part of the body or pipework, which are easily damaged. Rest the other end of the lever against a sturdy part of the pump mounting bracket on the engine.