How do you reset the maintenance indicator on a Nissan Versa?
Turn the ignition to the “RUN” position. The wrench symbol light will turn on for about 5 seconds, then turn off. Press the “TRIP’ button and hold for 3 seconds during the time the wrench symbol is illuminated. The symbol and distance display will begin to flash and will show the current interval.
How do you reset the TPMS light on a Nissan Versa?
Tap relatively slowly and hold the wire to the metal long enough to ensure your making good contact. (don’t worry it won’t spark there is little or no current in this wire) Step 6 If you did step 5 correctly your TPMS light should start flashing slowly.
How does the wrench symbol work on a Nissan Versa?
The wrench symbol light will turn on for about 5 seconds, then turn off. Press the “TRIP’ button and hold for 3 seconds during the time the wrench symbol is illuminated. The symbol and distance display will begin to flash and will show the current interval.
How often does the tire pressure beep on a Nissan Versa?
If the tire is over-inflated more than approximately 4 psi (30 kPa), the horn beeps and the hazard indicators flash 3 times. To correct the pressure, push the core of the valve stem on the tire briefly to release pressure. When the pressure reaches the designated pressure, the horn beeps once.
Turn the ignition to the “RUN” position. The wrench symbol light will turn on for about 5 seconds, then turn off. Press the “TRIP’ button and hold for 3 seconds during the time the wrench symbol is illuminated. The symbol and distance display will begin to flash and will show the current interval.
Tap relatively slowly and hold the wire to the metal long enough to ensure your making good contact. (don’t worry it won’t spark there is little or no current in this wire) Step 6 If you did step 5 correctly your TPMS light should start flashing slowly.
How do you reset the Check Engine light on a Nissan?
After repairs are complete, the SES light must be reset. The SES light in a Nissan is frequently called a check-engine light in other makes. Open the driver’s side door and get into the drivers seat. Insert the key into the ignition and turn it a quarter turn so the ignition turns on, but the engine doesn’t start.
The wrench symbol light will turn on for about 5 seconds, then turn off. Press the “TRIP’ button and hold for 3 seconds during the time the wrench symbol is illuminated. The symbol and distance display will begin to flash and will show the current interval.