Where is the illumination wire on a car stereo for?
To do that, a little trick we do is to clip on your aftermarket harness to your factory harness. After its snapped on find the orange wire with the white strip. Follow that wire to the factory harness and see if there is wire in that same pin location.
What to do if your car stereo is not dim?
If the car audio system does have this setting, try adjusting it to the different dimmer settings. The car stereo may not function properly if the connectors between the receiver and the front panel are not clean. In order to prevent this, do the following: WARNING: There is a risk of personal injury.
How to use the illumination circuit in a vehicle?
Using the illumination circuit in a vehicle is fairly simple. The first thing to do is to verify that you actually have a connection for that option on your factory radio harness (the harness you unplug from your factory radio). To do that, a little trick we do is to clip on your aftermarket harness to your factory harness.
What happens when the radio goes out on a Honda Accord?
The AC controls don’t work the whole unit is off, nothing works, defrost, front and rear, heat or air does not work. The radio works, but nothing else. Display lights for heat/AC and radio went out. Radio and CD player continued to operate for awhile, now they have ceased to function. Radio backlight is out.
To do that, a little trick we do is to clip on your aftermarket harness to your factory harness. After its snapped on find the orange wire with the white strip. Follow that wire to the factory harness and see if there is wire in that same pin location.
What should I do if my car stereo is not working?
Pull out the new car stereo to gain access to the wires again. Look for a blue wire on the aftermarket head unit and ensure that it’s connected to a corresponding wire within your vehicle’s wire harness. The Blue or Blue/White wire on your aftermarket head unit is what powers a powered antenna.
Using the illumination circuit in a vehicle is fairly simple. The first thing to do is to verify that you actually have a connection for that option on your factory radio harness (the harness you unplug from your factory radio). To do that, a little trick we do is to clip on your aftermarket harness to your factory harness.
Why does my car stereo go into protection mode?
If your alternator is producing too much power, it will trigger the amplifier’s protection mode. Vice versa, if your battery is low and the amplifier is not receiving a constant 12v, it will enter protection mode. Amplifiers will also enter protection mode if there is a short somewhere.