What kind of lug nut does Nissan Altima have?
Here is a list of lug nut torque specs and sizes for a Nissan Altima. Reference the model year in the table to see what lug nut torque and size is applicable for your car.
Why is my Nissan Altima battery draining while driving?
If it is draining while your Altima is off, it’s usually caused by something that is drawing current that shouldn’t be. If the battery is draining while you’re driving, that is probably going to be the alternator or battery. There are other situations as well. We’ll cover those for you below.
What’s the best way to install a new strut?
Installing the new strut is the reverse of the removal, but it’s very tricky and sometimes impossible to get it into place and hold it there while you get the nuts started. So enlist the help of a friend for the actual installation. Once it’s in place, torque the strut mount nuts to spec.
Why is oil leaking from top of my strut?
A very light film of oil near the top of the strut is OK, but fluid leaking down the side of the strut means it’s shot. You notice bounce, sway or front-end dive during braking. It’s hard to keep your vehicle in its own lane on bumpy roads and curves.
What kind of suspension system does Nissan Altima have?
Both the front and rear suspension systems on the Nissan Altima are a strut/coil spring design with the upper end of each strut attached to the vehicle body and the lower end connected to the steering knuckle.
How big should the steering knuckle be on an Altima?
Slide the steering knuckle into the strut flange and insert two new bolts. Install new nuts and tighten to the proper torque specification with a torque wrench. For a 1993 through 1997 Altima, tighten to 87 to 108 ft. lbs. For a 1998 through 2001 Altima, tighten to 123 to 127 ft. lbs. For a 2002 and later Altima, tighten to 93 to 114 ft. lbs.
How big should the struts be on a 2003 Altima?
For a 2003 and later Altima, tighten to 31 to 37 ft lbs. Insert the strut assembly up into the fender well and place the upper mounting studs through the holes in the shock tower.
How big of a shock do you need for an Altima?
For a 1993 through 2001 Altima, torque to 29 to 40 ft lbs. For a 2002 Altima, tighten to 13 to 16 ft lbs. For a 2003 and later Altima, tighten to 31 to 37 ft lbs. Insert the strut assembly up into the fender well and place the upper mounting studs through the holes in the shock tower.