How do you troubleshoot the SRS light on a Honda Civic?
Troubleshoot the SRS by finding the blue 2-pin service check connector underneath your glovebox. Turn off the ignition. Wait ten seconds, then connect the U shaped paperclip to the connector. Turn on the ignition and wait for the SRS light to give you a code.
Is there a way to reset the SRS light?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.
How to reset Honda Civic airbag SRS light air bag?
Honda Airbag SRS Module Crash Reset After Accident. An error occurred while retrieving sharing information. Please try again later. AIRBAG LIGHT ON ?
Where is the fuse for the SRS light?
In most models, this is fuse #40, located in the lower right corner of the fuse block. Turn the ignition switch to “ON” without starting the engine. Leave the ignition on for about one minute to allow the system a chance to reset. Turn the ignition off.
Troubleshoot the SRS by finding the blue 2-pin service check connector underneath your glovebox. Turn off the ignition. Wait ten seconds, then connect the U shaped paperclip to the connector. Turn on the ignition and wait for the SRS light to give you a code.
How do you turn off the SRS light?
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
What does SRS stand for in Honda Civic?
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
What does long Blink on SRS light mean?
Any code with 5, 6, 7, 8, or 10 long blinks means that the problem is with the SRS module. If the code is a 1 or 2 then the problem is with the driver’s or passenger’s air bags respectively. If the code is a 9 then the problem is with the power supply. Figure 3. Service check connector under the glovebox.
Why does the SRS light keep coming on?
For example, a long flash would indicate an error code of 10. Three short flashes would indicate an error code of 3. If there is an ongoing failure, the code will flash repeatedly. If the problem is intermittent, the code will flash once, and then the SRS light will just stay on.
What are the DTC codes for Honda SRS airbags?
Honda SRS Airbag DTC Codes. 1 Honda 1988-2002 All Models Codes: 1-1 & 1-2 open circuited Or high Resistance In Drivers Air Bag Inflator 1-3 short circuited To Another Wire In 2 Honda 2002-2011 All Models Codes: 3 Honda CIVIC, CR-V, ELEMENT & RIDGELINE Codes: 4 Honda ODYSSEY Codes: 5 Honda INSIGHT, PILOT S2000 Codes:
Where is the SRS unit on a Honda Accord?
The SRS unit is mounted on the floorboard near the firewall, which is behind the stock radio. To access the unit, remove the center console and two side panels. There is one screw and one clip on the driver’s side. There are two clips on the passenger’s side.
Why is my SRS light not code 9-3?
If your code is not 9-3 then this will probably not fix your problem. These are codes that I found online, I do not have the service manual (or the pages referred to in the list). Internal failure of the SRS unit. If intermittent, could mean internal failure of the unit or a faulty indicator light circuit.
What happens when you reset the SRS light?
The SRS light will blink twice to indicate that its memory has been erased. Turn off the ignition and wait ten seconds to restart the car. The light should come on for a moment then go out. Figure 2. SRS light (highlighted above) will blink twice when it’s been reset.
Any code with 5, 6, 7, 8, or 10 long blinks means that the problem is with the SRS module. If the code is a 1 or 2 then the problem is with the driver’s or passenger’s air bags respectively. If the code is a 9 then the problem is with the power supply. Figure 3. Service check connector under the glovebox.
What does the SRS light on a Honda Civic mean?
The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000).
What does it mean when SRS warning light stays on?
SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system. It is very unlikely that your airbags are going to deploy randomly, but the concern is that they may not deploy…
How do you reset the SRS light on a Honda CRV?
Put the key in the ignition and turn it on, but don’t start the engine. Keep the ends of the wire touching while you do this. The SRS light will flash on, and then disappear. Separate the wires immediately. The SRS light should come on again. Repeat Step 3 and the SRS light will blink twice and turn off.
What to do when your Mercedes SRS light goes off?
Unplug the scan tool and put the fuse panel cover back in place. Take your vehicle to your local Mercedes dealer to have repairs made, if needed. Repeat step 1 when you return home. Put the key into the ignition and turn it to the “Run” position. Wait until the SRS light turns off.
Where is the MES connector on a Honda Civic?
The MES connector is a yellow connector at the top right of the fuse box that connects to an empty socket. Unplug it and pull it out. Figure 1. Circled is the MES connector.
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
The MES connector is a yellow connector at the top right of the fuse box that connects to an empty socket. Unplug it and pull it out. Figure 1. Circled is the MES connector.
Where is the memory erase signal on a Honda?
Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash. In this step, you will internally make the connection in the plug to “short” it.
When does the ABS light come on on a Honda Civic?
Your Honda Civic’s ABS Light comes on when it fails a self diagnostic cycle. When on, it indicates that the Civic does not have Anti-Lock brakes, and the safety they provide. Your Civic’s ABS system uses a system of sensors to determine wheel speed when braking.
What does the brake light mean on a Honda Civic?
The brake light indicates that there is a problem with the physical braking system and that your Civic is unsafe to drive. Yes, you can drive your Civic with the ABS light on. Is it safe? It’s not as safe, especially when it’s raining, snowing, or the road surface is loose/uneven.
Is it safe to drive a Honda Civic without ABS?
Skidding tires also create flat spots in the tire, which can be inconvenient and dangerous in itself. ABS also allows you to be able to steer the vehicle while slowing down, and has been around for so long that many drivers have never driven a vehicle without it. Is it Safe to Drive Your Civic?
Why do I need to Reset my ECU on my Honda Civic?
After you install aftermarket parts, resetting the ECU will help your car’s computer “learn” and accommodate the new parts. Sometimes a faulty check engine light may appear, so resetting the ECU can make it go away. If any of these problems are affecting your Civic or Accord, it is very simple to reset the ECU.
Why does the SRS light come on while driving?
But if it stays on while you drive, or comes on while you’re driving, it indicates a problem with your airbags or some other part of the SRS. Let’s take a brief look at how your airbag system works, reasons the SRS light can come on, and why it’s OK to drive with the light on, but only if you get it fixed quickly.
How do you reset the SRS light on a Honda Civic?
Disconnect the paper clip as soon as the light goes off. When light comes back on reconnect the paperclip. Wait for the light to go off once more then disconnect the paperclip. The SRS light will blink twice to indicate that its memory has been erased. Turn off the ignition and wait ten seconds to restart the car.
How can I get my Honda dash lights to stay on?
Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. I used a paper clip, but any stiff (solid) light gauge wire will do.
Why does my Honda SRS light keep blinking?
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
What does SRS warning light on dashboard look like?
The SRS warning light on the dashboard usually looks like a side view of a person sitting in a seat with a seat belt on, with a large circle (the airbag) in front of the person.
If your code is not 9-3 then this will probably not fix your problem. These are codes that I found online, I do not have the service manual (or the pages referred to in the list). Internal failure of the SRS unit. If intermittent, could mean internal failure of the unit or a faulty indicator light circuit.
Why is my SRS light not working on my Honda Accord?
Tried the battery thing, the MES plug light reset and basically nothing works, Most cheap scanners including the Snapon Solus-Pro won’t read air bag .or abs codes.
How can I tell if my SRS light is on?
The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.
What does the SRS light mean on a Honda Accord?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.
The SRS light should go off. When the light goes off, pull the wires apart. The SRS light should blink twice. Turn off the ignition to start your car as normal. The SRS light should come on, and after a few seconds it will turn off and stay off. Figure 1. Connect a pair of stripped wires to short the MES. Figure 2.
What does the SRS light on airbags mean?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.
What does it mean when the SRS light comes on?
Self-Test: The light should always come on for a few seconds when you crank the engine. This is a self-test, and the light should go out quickly. If the SRS indicator comes on at any other point, it means that there’s a problem with the system. If the SRS indicator is on or flashing, have your system inspected as soon as possible.
How can I tell if my SRS is working?
Unless checked and repaired, the SRS will not function reliably. A malfunction is shown by: The indicator light flashing or flickering. The SRS indicator light failing to illuminate when the ignition switch is first turned to the II position. The SRS indicator light continuously illuminated. The SRS indicator light illuminated while driving.
For example, a long flash would indicate an error code of 10. Three short flashes would indicate an error code of 3. If there is an ongoing failure, the code will flash repeatedly. If the problem is intermittent, the code will flash once, and then the SRS light will just stay on.
The SRS unit is mounted on the floorboard near the firewall, which is behind the stock radio. To access the unit, remove the center console and two side panels. There is one screw and one clip on the driver’s side. There are two clips on the passenger’s side.
Why does the SRS light stay on after an accident?
If the car has been in an accident and the air bags went off will the srs light stay on simply because they didn’t reset the system or would it most likely be that the scum dealer I bought this pos from didnt even replace the air bags or anything from the accident…
Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice.
Where is the SRS fuse on a Honda Civic EX coupe?
It’s just to the right of the steering shaft behind the center console. Here is the YELLOW SRS service connector located on the fuse panel. Unplug the YELLOW SRS service connector. All you need is a paper clip, bend it in 1/2 & insert it into the YELLOW SRS service connector (not the actual fuse panel).
How to reset Honda Civic EX coupe SRS light?
1- W/ the igniton switch “off”, insert the paper clip ito the connector 2- Turn the ignition switch to the “ON” position. 3- The SRS light will come on for 6sec & then turn off. Remove the paperclip w/in 4sec of the SRS light turning off. 4- The SRS light will turn on again. Re-connect the paperclip w/in 4sec of the SRS light turning on.