What is a stop light switch?
The stop light switch (Fig. 22) is an air-signaled electrical switch which is turned on any time a brake application is made. The switch is usually connected to a double check valve and can be plumbed anywhere in the application side of the circuit.
Where is the brake light stop switch located?
Locate brake light stop switch The brake light switch is located right above the brake pedal. To access it, remove the underside panel cover. Usually, the panel is held in place with 3 to 5 screws.
Where are the fuse panels on a Nissan Xterra?
Here you will find fuse box diagrams of Nissan Xterra 1999, 2000, 2001, 2002, 2003 and 2004, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Why does my 2000 Xterra air conditioner not work?
The 2000 Xterra’s Air Conditioning is sometimes cool but may not work other times. The Air Conditioning System will get cold when the Compressor Clutch is engaged but the clutch quickly quits and just blows semi cool to warm air. One possible cause of this symptom is that the Thermistor may be defective.
What to do if your brake light switch is not working?
Try turning off the engine and remove the key, wait a few seconds and restart the car. That may solve the problem temporarily. Even though the problem could be multiple things, the brake stop light switch is the first thing you should inspect. Which Mercedes-Benz models are impacted by the defective brake light switch?
Where is the brake light switch on a car?
To get to the switch, take a look right above brake pedal. The switch is typically a small plastic box with 2 or 3 wires coming from it. It will make contact with the brake lever towards the top. Note: You may have to remove a plastic panel before you can access this area.
Why is my brake light switch not working?
The most common symptom of a brake switch issue is no illumination when stepping on the brakes. It is also possible for the reverse of this to happen, where the plunger breaks in such a way that the terminals are permanently connected and the lights are always on. Certain types of switches can be adjusted and over time may become misaligned.
Can a old brake light switch be replaced?
Tip: With an older style switch, you may have to adjust the position of the sensor for the lights to work properly. With a little time and patience, you should have your new switch installed and your brake lights should be working.