What happens with a bad condenser?
A failing points and condenser system can cause rough running, misfires, lean and rich conditions. If your vehicle runs rough, the engine will not fire, or the vehicle will not start at all, it may the points and condenser system that is the issue.
What does the p1320 code on a Nissan mean?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The most common cause that will trigger the P1320 code is the ignition coils, one or more ignition coils may have failed.
What causes the p1320 sensor to be set?
Factors like abnormal electrical resistances in wiring, crankshaft position sensor, ignition coil power transistors, or even the ignition coil itself can cause code P1320 to set, or contribute to its setting, which will cause a warning light to be illuminated. Where is the P1320 sensor located?
How much does it cost to repair a Nissan p1320?
Please try again later. The cost of diagnosing the P1320 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
When is the ignition signal not sent to the ECM?
When the ignition signal in the primary circuit is not sent to Engine Control Module (ECM) during engine cranking or running. P1320 NISSAN Possible Symptoms Engine Light ON (or Service Engine Soon Warning Light) P1320 Nissan Description The ignition signal from the Engine Control Module (ECM) is sent to and amplified by the power transistor.
What do you need to know about Nissan code p1320?
However, as far as code P1320 is concerned on Nissan applications, we need only consider the process of delivering a spark to each cylinder, which happens in the following manner on a fully functional ignition system-
What does OBD II fault code p1320 mean?
What Does Code P1320 Mean? OBD II fault code P1320 is a manufacturer specific code that is defined by carmaker Nissan as “Ignition Signal Primary – circuit malfunction”, and is set when the PCM (Powertrain Control Module) detects a failure or malfunction in one or more primary ignition circuits.
Factors like abnormal electrical resistances in wiring, crankshaft position sensor, ignition coil power transistors, or even the ignition coil itself can cause code P1320 to set, or contribute to its setting, which will cause a warning light to be illuminated. Where is the P1320 sensor located?