What causes the p0328 OBD-II trouble code?
What causes the P0328 code? 1 Faulty knock sensor 1, bank 1 2 Open or short in knock sensor circuit wiring 3 Failed ECU 4 Wrong octane fuel or lean air fuel ration 5 Engine is overheating 6 Low fuel pressure
What does it mean when your knock sensor says p0328?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The P0328 code means that the Knock Sensor is not working correctly. Problems with the knock sensor will not cause engine performance problems.
What does p0328 stand for in PCMs?
Most PCMs have the ability to learn spark knock trends in the engine during normal operation. A P0328 code is a generic DTC, thus it applies to all makes of vehicles, and refers to a high output voltage of the knock sensor.
What is the hard fault code for Nissan Xterra?
The car has a hard fault code P0325 Knock Sensor Circuit Malfunction. After diagnostic was performed it was determined that the knock sensor would have to be replaced. Unforchanetly on this Nissan Xterra, the knock sensor is not acceptable unless the upper and lower intake manifolds are removed.
What does the p0328 code on a Nissan mean?
The P0328 code means that the Knock Sensor is not working properly. Problems with the knock sensor will not cause an engine performance problems. Replacing the knock sensor usually takes care of the problem. The cost to diagnose the P0328 NISSAN code is 1.0 hour of labor.
When do I need to fix trouble code p0102?
A trouble code P0102 is triggered when there is low airflow registered by the Mass Air Flow, or MAF, sensor. When this happens, you need to know how do I fix trouble code P0102?
What does the p0328 code on a knock sensor mean?
The P0328 code means that the Knock Sensor is not working properly. Problems with the knock sensor will not cause an engine performance problems. Replacing the knock sensor usually takes care of the problem.
What does p0102 mean on the MAF sensor?
The Mass Airflow (MAF) sensor measures the amount of air entering the engine. When code P0102 is set, there is a low voltage output to the ECM, PCM, or ECU depending on your car type (check your owner’s manual for your specific car). P0102 Symptoms