When to take care of your Nissan drive belt?
Although it is made of a strong rubber, it still can be worn one day. Generally speaking, if you drive your Nissan more than three or five years, or 45,000 or 75,000 miles, then it is the chance for you to take care of your drive belt.
Are there any problems with the Nissan Quest?
Check out our Nissan Quest overview to see the most problematic years, worst problems and most recently reported complaints with the Quest.
Where to replace the serpentine belt on a Nissan Maxima?
Replace the serpentine belt if there are pieces missing from the belt or if the belt has a lot of cracks within the ribs of the belt. Park the 2005 Nissan Maxima and engage the emergency brake. Raise the hood and secure it in place. Locate the front belt on the front of the engine.
What kind of drive belt does a Nissan have?
About Nissan Drive Belt. As its name shows, drive belt drives some components in your engine, like water pump, power steering pump, alternator and air conditioner compressor. You may have one or two drive belt in your Nissan car. Although it is made of a strong rubber, it still can be worn one day.
What should I do if my Nissan truck has a vacuum leak?
Often it’s as simple as tracking down a vacuum leak, which is far cheaper than replacing your car’s engine control unit (ECU). This question came from a reader who owns a 1997 Nissan pickup truck. The small engine in this truck is similar to many other engines in Nissans and other makes.
How do you change fan belt on Nissan Patrol?
How to Change the Belt on a Nissan Patrol Turbo Diesel Turn the engine off, allowing it enough time to cool. This will save you the trouble of receiving burns while working under the hood. Pop the hood of the car and locate the fan belt attached to the side of the engine. Loosen the nuts that create tension on the connecting pulleys.
How can you tell if a new belt is the wrong belt?
Look at the new belt in comparison to the old one to be sure they are the same width and have the same number of ribs going across the belt horizontally. The old belt may be slightly longer than the new one due to stretching. If the new belt is not the same width as the old one, it is the wrong belt.
What to do if your belt is loose after routing?
If the belt is loose after routing it, it is either the wrong size belt or you’ve routed it incorrectly. Apply pressure on the auto tensioner and put the belt over it. Use the same wrench to loosen the auto tensioner pulley, then pull the belt over it. Once the belt is in place, release the pressure on the tensioner so it holds the belt in place.
How do you tighten a serpentine belt on a car?
If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt. Tighten the bolts again as you apply tension.
How often should a serpentine belt be replaced?
Most serpentine belts need to be replaced every 40,000 to 70,000 miles. If there are signs of the belt rubbing on something, make sure to identify and repair whatever it was rubbing on to avoid damaging the new belt.