How do you remove blend door actuator on Nissan Alti?
Has anyone found or know of a quick way to get to this without tearing apart the dash? I know on some vehicles you can use a hot knife and cut away at the vents and access that way, not sure on Alti.
Do you need a Nissan Altima door actuator?
Enter your VIN for the most accurate results. Enter your VIN for the most accurate results. We offer a full selection of genuine Nissan Altima Blend Door Actuators, engineered specifically to restore factory performance.
Where is the blend door actuator on a manual AC system?
Those are the actuators on the manual AC system. The mix/blend door actuator is reached by removing the glove box trim strip on the right, then remove the screws around the glove box, disconnect the wire connector and remove the box. Inside you will see a duct connection that you need to remove and the blend actuator is behind it.
How to remove and replace a blend door?
1. Remove the glove box assembly. Refer to “Removal and Installation” See: Glove Compartment > Removal and Replacement > Removal and Installation. 2. Remove the upper floor connecting duct (RH). Refer to “Exploded View” See: Housing Assembly HVAC > Removal and Replacement > Exploded View.
Has anyone found or know of a quick way to get to this without tearing apart the dash? I know on some vehicles you can use a hot knife and cut away at the vents and access that way, not sure on Alti.
Enter your VIN for the most accurate results. Enter your VIN for the most accurate results. We offer a full selection of genuine Nissan Altima Blend Door Actuators, engineered specifically to restore factory performance.
How to reassemble a Nissan air mix door?
To reassemble take the bottom half with the motor, one gear and encoder (blue thing with 3 pins) and the top half with the half-gear and 2more gears. Putting it back together takes some patience but it can only fit one way;-)
Where is the air mix motor on a Nissan?
(Top right for right-hand steering, top left for left hand steering) 3. You can now see the blower motor, cooling unit etc. The air mix door motor is next to the center console, a small black box. From underneath you should see the arm that connects the motor and the air mix door.