How do I turn off the maintenance required light on my Nissan Altima?
Use the “Up” and “Down” arrow buttons on the steering wheel to toggle the selection to “Maintenance“. Press the “OK” button on the steering wheel to go into the “Maintenance” menu. Use the “Up” and “Down” arrows to toggle the selection to “Oil Control System“. Press the “OK” button to choose “Reset“.
How to do idle Relearn on a Nissan Altima?
Turn the ignition switch back on for at least two more seconds, then off again. Turn the ignition switch on again and wait two seconds, then off again for 10 seconds. Make sure you can hear the electric motor on the throttle moving at this time. It will make a buzzing sound. Start the engine and run it until it gets to operating temperature.
When to release the pedal on a Nissan Altima?
Release the pedal within three seconds after the light becomes solid. Start the engine and let it idle, wait 20 seconds, then rev the engine a few times and make sure the idle returns to normal idle speed.
How to idle relearn procedure for Nissan Leaf?
Turn the key to OFF and wait at least 10-secs. Foot off the pedal, turn key to ON and 3-secs. Repeat the following procedure quickly FIVE times within 5 seconds. Pedal to the floor, then full release.
Can you perform idle air volume learning on Nissan?
Normally, the idle learning can be completed if operate per the above-mentioned steps. While, it can’t be completed sometimes mainly due to the water temperature which exceeds 90 ℃. For Nissan Idle learning, it has strict requirements on water temperature, i.e. it should not exceed 90 ℃, otherwise the idle learning can’t be co mpleted.
Turn the ignition switch back on for at least two more seconds, then off again. Turn the ignition switch on again and wait two seconds, then off again for 10 seconds. Make sure you can hear the electric motor on the throttle moving at this time. It will make a buzzing sound. Start the engine and run it until it gets to operating temperature.
Release the pedal within three seconds after the light becomes solid. Start the engine and let it idle, wait 20 seconds, then rev the engine a few times and make sure the idle returns to normal idle speed.
Turn the key to OFF and wait at least 10-secs. Foot off the pedal, turn key to ON and 3-secs. Repeat the following procedure quickly FIVE times within 5 seconds. Pedal to the floor, then full release.
When to release accelerator pedal for idle relearn?
Pedal to the floor, then full release. After the 5 pedal presses, wait 7 seconds and depress the accelerator pedal to the floor again and keep it there for approx. 20 seconds until the malfunction light stops blinking and turns ON steady. Release the accelerator pedal within 3 seconds after malfunction light stops blinking and turns ON steady.