What happens if you replace the water pump in a Nissan Xterra?
Check the coolant you drained from the Xterra’s radiator. If the coolant is contaminated or dirty, replace it. Contaminated cooling can damage a new water pump. Refill the coolant level and start the engine to check for leaks from the radiator and the water pump.
What kind of engine does a Nissan Xterra have?
The Nissan Xterra is a compact sport utility vehicle intended for off-road use. Nissan began production of this product line in 2000, and the most recent generation of the Xterra includes 2005 and later models. The only engine available for the Nissan Xterra is a six-cylinder 4.0-liter engine, which has the oil pump on the front of the crankcase.
How do you install an oil pump on a Nissan Xterra?
Add a layer of sealant to the mounting surfaces of the oil pans and install the oil pans. Allow the sealant to cure for 30 minutes before you add oil. Fill the crankcase with the proper amount of oil and coolant. Start the engine and check for oil and coolant leaks.
Check the coolant you drained from the Xterra’s radiator. If the coolant is contaminated or dirty, replace it. Contaminated cooling can damage a new water pump. Refill the coolant level and start the engine to check for leaks from the radiator and the water pump.
What should I do if my water pump is not working?
As discussed above, an engine will maintain a consistent temperature when the water pump works correctly and circulates water to a functioning radiator. If you notice steam coming from the front of your motor, you should pull over to a safe area and contact a mechanic as soon as possible.
What happens when a car water pump breaks?
Eventually, these gaskets and seals will wear out, dry up, crack or break entirely. When this happens, coolant will leak from the water pump and drop to the ground, typically in the front of your car and in the center of the motor’s location.
How do you replace a water pump on a Nissan?
Once the belts and the large bottom pulley is off, remove the 2 parts of the casing on the engine. There two small pulleys right together around the timing belt, losen the bolt on the left one and it should give you enough slack to remove the timing belt. Here is where I got confused.
How do you install a water pump on a V-6 engine?
Fill the indentation around the back of the pump. For V-6 engines, fit the new O-ring gasket to the water pump’s mounting point. Attach the water pump with the torque wrench. Tighten the bolts to between 12 and 15 foot-pounds. Reattach the water pump pulley and the accessory belt. Install the cooling fan shroud back in its place.