How do you replace the camshaft position sensor?
Replace the camshaft position sensor. Using the scan tool perform the ”Cam/Crank Relearn” procedure. Note: Inspect the camshaft magnetic target for damage. if a problem is found repair as necessary. Reconnect the PCM and CMP sensor 1 harness connectors. Turn the ignition on, with the scan tool, erase DTC.
What is the voltage of the p0340 camshaft sensor?
P0340 Camshaft Position Sensor Circuit – Bank 1 Sensor 1, battery voltage is above approximately 11.0 volts, with the engine cranking and with the engine running.
When does the crankshaft position sensor become inoperative?
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing the timing of cylinder identification signals. Need more information on how to fix the P0340 NISSAN code?
Where is the camshaft position sensor located on a Nissan Altima?
Nissan models with a distributor, the camshaft position sensor are part of the distributor. Code P0725 / P0335 / P0340 – Camshaft Positioning Sensor Replacement – Nissan Altima. If playback doesn’t begin shortly, try restarting your device.
When to replace the camshaft position sensor Bank 1?
Pulled the code PO340 camshaft position sensor Bank 1. Dealer “recommended” to replace both, but just going to tackle Bank 1 first and test. How hard was this on scale 1-10.
What’s the best place to replace a camshaft sensor?
That’s what it takes to replace your camshaft position sensor. If this seems like something you’d prefer to leave to a professional, YourMechanic offers expert camshaft position sensor replacement. The most popular service booked by readers of this article is Camshaft Position Sensor Replacement.
Where is the intake camshaft position sensor located?
The crankshaft position sensor is located in the lower right rear of the engine block near the transmission bell housing. The intake camshaft position sensor is located near the left rear corner of the engine head. The exhaust camshaft position sensor is located near the right rear corner of the engine head.
Is the crank sensor connected to the cam sensor?
The later ECU is signaled by the crankshaft sensor only as far as I know. I was wondering if the crankshaft sensor on the earlier twincam could be wired to both ECU connections (to provide both cam and crank sensor signals) in order to eliminate the cam sensor.