Where do you place the choke plate on a Honda Accord?
If the choke lever uses a detent spring to control the choke plate position, guide the spring into the notched slot on the choke lever. Place the choke plate on the shaft with the single notch on the edge toward the fuel inlet.
How do you change the height of a clutch pedal?
Tighten the adjusting bolt on the pedal until it touches the pedal again, then turn it ¾ to a full turn more and re-tighten the locknut. Change the height of the pedal by loosening the second and highest locknut on the clutch pedal, then measure the height of the pedal from the floor when you press it completely down.
How do you bleed air out of a clutch pedal?
Release the bleeder valve and attach a hose to it. Put the other end of the hose in a container with clutch pedal fluid. Pump the clutch pedal a few times to bleed the fluid from the system, and stop after you don’t see any more air bubbles in the container.
Where does the lead go on an eight cylinder car?
Eight-cylinder vehicles are taken from the four-cylinder scale and halved. Follow the maker’s instructions. Normally one lead is connected to the side terminal of the distributor if it is outside the distributor body, or the CB (contact-breaker) terminal on the coil , and the other to earth.
Is there a way to adjust the automatic choke?
To adjust your automatic choke for less air or if it needs adjustment, here are the steps you should follow. Remove the automatic choke screws that hold the cover in place. Rotate the cap until the notch lines up to the indicator on your carburetor housing.
Where do I put the choke control cable?
Loosen the cable clamp screw on the bottom front side of the intake manifold for a forward pull choke, or on the air intake elbow for a reverse pull. 2. Place the choke control cable under the intake manifold from the front of engine (front pull choke). Insert the cable bowden wire into the choke control (front or reverse pull).
How do you remove a choke from a carburetor?
Park the vehicle and shut off the engine. Wait a couple of hours for the engine to cool completely. Raise the hood and lock it in place. Unscrew the wing nut from the air cleaner assembly with pliers and remove it from the top of the carburetor. Locate the automatic choke element on the right side of the carburetor.
Where is the choke on a air cleaner?
Unscrew the wing nut from the air cleaner assembly with pliers and remove it from the top of the carburetor. Locate the automatic choke element on the right side of the carburetor. The automatic choke element is round, with three screws that mount it to the carburetor. Locate the throttle lever on the left side of the carburetor.