What is the white wire on the 350Z headunit?
Blue & White Striped Wire on Bullet Connectors – This is used normally to connect to external amplifiers and it controls the power on them (like a digital on/off switch). In our case, the 350z has a power antenna, so we need to use this wire for that. It also controls the power to the factory fitted BOSE amplifier on the GT spec cars.
Do you need power antenna for Bose 350Z?
In our case, the 350z has a power antenna, so we need to use this wire for that. It also controls the power to the factory fitted BOSE amplifier on the GT spec cars.
Where to find parking brake detection wire on 350Z?
You should be able to follow this back through the connection block and see it matches up to the black wire on the head unit loom. Locate the green parking brake detection wire on the head unit loom. Cut this, and the black cable on the same loom to the same length and twist together as shown.
Is the pioneer 350Z headunit replacement guide out of date?
They all seemed to be either out of date, or hastily written so didn’t cover enough details. Hopefully this guide should patch up those flaws. It is written showing the install of a Pioneer SPH-DA120 AppRadio, but the basic principles apply for any stereo install.
Blue & White Striped Wire on Bullet Connectors – This is used normally to connect to external amplifiers and it controls the power on them (like a digital on/off switch). In our case, the 350z has a power antenna, so we need to use this wire for that. It also controls the power to the factory fitted BOSE amplifier on the GT spec cars.
In our case, the 350z has a power antenna, so we need to use this wire for that. It also controls the power to the factory fitted BOSE amplifier on the GT spec cars.
How do you hook up a car stereo?
Normally, when you install a new stereo, all the wires from the stereo would connect to the car wiring adapter. The wires would run from one black connector to the other (the right side of the photo below).
You should be able to follow this back through the connection block and see it matches up to the black wire on the head unit loom. Locate the green parking brake detection wire on the head unit loom. Cut this, and the black cable on the same loom to the same length and twist together as shown.